LG Plasma 60PA6550-UF Pop No Picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • spicedrvr
    New Member
    • Oct 2012
    • 8
    • USA

    #1

    LG Plasma 60PA6550-UF Pop No Picture

    Y-Sustain had shorted transistors. New Y-Sustain has no picture. Removing either buffer board will show colored noise with vertical bars on either top or bottom of screen.

    Buffers replaced - no change. 2nd Y-Sustain replaced - no change.

    When you listen closely to the Y-Sustains operating, there is a short chirp. As if a switch mode power supply was operating with a shorted output line.

    Is this a bad panel ?
  • Andrew F. Ali
    Badcaps Legend
    • Jan 2014
    • 2450
    • Trinidad & Tobago

    #2
    Re: LG Plasma 60PA6550-UF Pop No Picture

    Look at the Z-sus Bd. It may have some shorted FETs and/or loose coils.

    Comment

    Related Topics

    Collapse

    • EazyBone
      Un70TU7000b Backlights work, no picture, has sound, panel shorted caps
      by EazyBone
      Picked up this Samsung above thinking it'd be backlights but it isn't. Now MAYBE I'll get lucky.
      Found some shorted caps among the panel boards. Each cap along the line is shorted. On every board (3 panel driver boards)I disconnect each side right and left ribbons and they are no longer shorted caps and have about 1.5Mohm resistance (on left and right boards). The middle board has the main board disconnected and the caps are shorted. Last 4 pics show arrow to caps.

      Now what exactly do I need to do in order to attempt to fix this issue?

      do I have to take each one...
      12-24-2023, 06:59 PM
    • KYBOSH
      Trying to Save - LG 60PH6700 60-inch plasma HDTV - Powers ON but no picture
      by KYBOSH
      Saved this beast from the landfill this weekend.
      Manfactured July 2013 in Mexico.

      I love working on plasma TVs.
      Its been a while but I was lucky enough to find 2 this week.

      The TV powers on and stays on but no picture. Havent checked for sound yet.
      No bulging caps although the insides are pretty dusty and the boards are discolored from many years of high heat.
      Will start troubleshooting tonight.

      ...
      10-17-2024, 01:17 PM
    • Tr0ll
      T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
      by Tr0ll
      Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

      The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

      Original T-con:
      Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

      First replacement T-con:

      I thought it might be t-con and ordered new t-con from china(supposedly tested)...
      10-07-2023, 07:48 PM
    • JJAAMM
      SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
      by JJAAMM
      This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

      Problem
      TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
      07-06-2023, 06:01 AM
    • TR103
      Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
      by TR103
      Hi, I have a Samsung UE50TU with:
      - sound and backlight, but no picture
      - when it arrived, it had a picture for a few seconds
      - it keeps rebooting
      - without ribbon cable between the two panel boards, it does not reboot but I have no picture
      - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
      - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

      - without cable between mainboard and lcd panel and with a jumpered...
      01-22-2025, 04:12 PM
    • Loading...
    • No more items.
    Working...