General Fact-Finding Questions ELEMENT ELEFW504

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Michale32086
    New Member
    • Nov 2011
    • 1453
    • USA
    #1

    General Fact-Finding Questions ELEMENT ELEFW504

    Generally speaking, when I see the problems shown in the pics, I assume that it's a Panel issue that can't be fixed... Every once in a great while, simply reseating the TCON connections will fix the issue, but by and large it's a panel issue and hopeless..

    But sometimes, I get this situation where I disconnect one of the TCON connectors, I get a perfectly good screen on one side..

    Does this indicate that the panel may be good and it's a TCON problem??
    Attached Files
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • x_orange90_x
      TCL 50S535 bad tcon or panel issue?
      by x_orange90_x
      Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
      03-29-2025, 11:02 PM
    • mmartell
      General Questions on the Relationship Between Mainboard, TCON and Panel
      by mmartell
      My goal here is to be able to use boards on hand to swap into faulty sets when the faulty board is not obvious.

      I will start by asking what is the format of the output from the mainboard and is it generic in any way or does it vary by manufacturer and/or model ?
      ​
      And as far as I know a tcon and panel must be a matching pair because the timing of the signals and the voltages required to drive the panel are specific to the panel itself. (That may be a blanket statement that isn't true in some cases where the panel creates its own sub-voltages on its panel boards?)...
      01-06-2024, 01:32 PM
    • thelankanguy
      Sony KD-55X9000F TCON Issue
      by thelankanguy
      The TV shows a black screen with no image.
      TCON ribbon connectors were disconnected individually for image and there was no half image even.
      Later both ribbons were disconnected and TCON voltages were tested.
      12V, 3.3V, 1.8V were seen present but VONE signal reads 0V.
      There is also a short to ground in this circled inductor.
      Is this a TCON issue or something else ?...
      12-13-2024, 12:27 AM
    • cagri
      BOE HV650QUB-F70 TCON issue - VGH AVDD HAVDD no voltage - caps seem ok
      by cagri
      I have an Arcelik TV with BOE HV650QUB-F70 TCON board, but I think there's an issue with/around PMIC.
      PMIC: iML8940

      There is backlight and sound, but no picture. I watched a YouTube video and turned it off, half an hour later it was dead.

      Input 12v, fuse ok
      DVDD1V2 = 1.2v
      DVDD1V8 = 1.8v
      DVDD3V3 = 3.3v
      VGL = -7v
      **VGH = -0.3v
      **VCOM0, AVDD, HAVDD = 0v
      SWBK1 = 3.3v
      SW1 = 12v

      VGH to GND resistance is 500kohm as expected

      Readings are same after I disconnected the two cables from TCON to panel...
      07-27-2023, 09:48 PM
    • EazyBone
      Vizio P759-G1, Tcon issue?
      by EazyBone
      Got this TV free. Guy said it tries to turn on and doesn't. I haven't seen this specific issue before but shown in video. Any way to test the screen to rule it out on these Vizio? Or anyone seen this issue before?

      Any help appreciated

      https://youtu.be/tPeV2Q7TXIQ?feature=shared
      03-22-2024, 03:25 PM
    • Loading...
    • No more items.
    Working...