Lg 32ls345t

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • llonen
    Badcaps Veteran
    • Sep 2014
    • 495
    • hampshire
    #1

    Lg 32ls345t

    So this set came in from a customer the other day, does anyone know of a cheap source of replacement PSU's part number EAX65035501 (1.0) that are preferably in the Uk. The PSU repair would have been straightforward enough but some one got to it before me, not quite sure what they did to it as I can see no point of impact on the set or the board ???
    Attached Files
    Last edited by llonen; 10-27-2017, 03:12 AM.
    Tags: None
    • dick_barton
      Badcaps Legend
      • Aug 2015
      • 6642
      • Wales
      #2
      Re: Lg 32ls345t

      You can make EMOS an offer. Board is expensive so I couldn't see it selling so they may accept an offer.

      https://www.tvparts.co.uk/eax6503550...0-power-supply


      Edit.
      I see they too are out of stock. Looks like a repair may be your only option.
      Last edited by dick_barton; 10-27-2017, 04:33 AM.
      Willing to help but I'm no expert.

        Comment

        • diif
          Badcaps Legend
          • Feb 2014
          • 6978
          • England
          #3
          Re: Lg 32ls345t

          There looks to only be three traces cracked, why don't you try and repair before sourcing a replacement ?
          I suspect the previous "fixer" dropped the board on it's corner.

            Comment

            • dick_barton
              Badcaps Legend
              • Aug 2015
              • 6642
              • Wales
              #4
              Re: Lg 32ls345t

              Originally posted by diif
              There looks to only be three traces cracked, why don't you try and repair before sourcing a replacement ?
              I suspect the previous "fixer" dropped the board on it's corner.
              Well spotted. I didn't even see that crack. I agree with Diif that it should be an easy fix.

              If the supply isn't working then another site said:-

              "When the power supply was checked, it was immediately found that the failure was caused by the failure of the Q101 MDF10N65B power FET drain outlet and the "C102 330pF ceramic capacitor" of the "warm GND" due to a material fault.
              I got jammed with fix because I can not find any IC (IC101: SC1S311) of this type, but no substitute."
              Attached Files
              Last edited by dick_barton; 10-27-2017, 05:05 AM.
              Willing to help but I'm no expert.

                Comment

                • llonen
                  Badcaps Veteran
                  • Sep 2014
                  • 495
                  • hampshire
                  #5
                  Re: Lg 32ls345t

                  Any thoughts on the value of c102 not sure how I missed it the first time around see pic

                  Actually does anyone have a schematic for this board Eax65035501 1.0
                  Attached Files
                  Last edited by llonen; 11-06-2017, 07:30 PM.

                    Comment

                    • llonen
                      Badcaps Veteran
                      • Sep 2014
                      • 495
                      • hampshire
                      #6
                      Re: Lg 32ls345t

                      Sorry I can be real thick sometimes lol

                        Comment

                        • Martin Serrano
                          New Member
                          • Sep 2023
                          • 2
                          • Estados Unidos
                          #7
                          Re: Lg 32ls345t

                          Service Manual Panasonic Led EM32TS

                            Comment

                            Previous template Next

                            Related Topics

                            Collapse
                            • mecha1166
                              Anyone here fix a tv and customer cracks panel when they get it home?
                              by mecha1166
                              About 2 times a year, a customer will do this. We fix the tv, put it on test play, and customer sees it working. They see me pull power and video wire. Sometimes I pick up tv, right in front of them, and carry it out to their vehicle while they are next to me. I set it in their tv gently, and tell them the tv is very fragile, be careful with it. I let them close the door/trunk. That day, or a few days later, they tell me there is a crack inside the tv. Normally I tell them transportation is their responsibility and normally that is the end of it. Has anyone had a customer that was not buying this...
                              03-29-2024, 11:27 AM
                            • the_rem
                              Unknown transformer : how to find a good replacement part ?
                              by the_rem
                              Hello guys,

                              I would like a quite old but still good 800 W ATX PSU to be repaired. The problem was an extremely heavy coil whine coming from the small secondary transfomer on the PCB.

                              I desoldered it hoping the references on the upper side would allow me to find a adequate replacement part. Sadly the written references drove me nowhere but to the manufacturer (I-MAG). I sent them a message like a bottle in the see asking them to send me a datasheet of the transformer. And... They responded ! I received a kind of datasheet (see attachment) but my competencies do not allow...
                              VEF20FB07BW(2025001A)20110927.pdf
                              https://drive.google.com
                              04-23-2025, 01:48 AM
                            • ezenia
                              PS4 controller left stick potentiometer replacement issue
                              by ezenia
                              Hello,

                              Not sure if this is the correct section, but I have a PS4 controller that I am trying to fix. It developed stick drift on the left stick and the usual simpler methods did not fix the problem.

                              So I went on eBay and ordered some replacement potentiometers. https://www.ebay.co.uk/itm/174967976757 is where I got them from.

                              I took the green potentiometers off the replacement sticks and soldered them onto the PCB. Assembled the controller and ran some tests. The drifting was somewhat fixed (not fully in center, but way better than before). However,...
                              09-30-2023, 02:19 PM
                            • boosti45
                              Macbook pro logic board replacement parts quesion
                              by boosti45
                              i have a 2020 macbook pro 13" A2251 with 820-09149 logic board so i found an issue with chip labeled U6903 according to schem. boardview using flexBV software, so i removed it from the board and the issue im having is that the chip says "07A08FI ELC180​" on top of it but when searching for a replacement chip, i can find tons of identical looking chips that also have "ELC180" printed on them but the first set of digits is never the same so im trying to find out if i need this exact chip with these same numbers as mine and if not which ones are compatible as a replacement?...
                              08-21-2024, 05:23 AM
                            • r2digital
                              klipsch kda-500 amplifier suitable power supply capacitor replacement ?
                              by r2digital
                              I have a klipsch kda-500 that would turn on and allow me to get into the web management but it was picking up a lot of noise from audio sources so i decided to replace the smd caps on the power supply along with radial one. Some one was in here before me and they basically burned the bottom side of the traces off for the radial cap but i was able to repair it without any real problem. I thought i did a good job sourcing out replacement caps but apparently not and now i can't get the power supply to turn on it just constantly try's to keep turning on. Attached is a picture of the power supply before...
                              2 Photos
                              04-18-2024, 03:50 PM
                            • Loading...
                            • No more items.
                            Working...