Please check this video, the symptoms after 1 min
Is this power supply?
https://photos.app.goo.gl/lUEJxNfBMr8m9Vgp2
Is this power supply?
https://photos.app.goo.gl/lUEJxNfBMr8m9Vgp2
-
-
Re: Olevia 237-T12 horisontal lines after 1 min
any thoughts anyone?
I now lean towards bad T-CON -
Re: Olevia 237-T12 horisontal lines after 1 min
Looks like Backlights to me.....However,.....Remove the back...Upload pics of the boards and their lay-out...Measure and post voltages on PSU.Comment
-
Re: Olevia 237-T12 horisontal lines after 1 min
Here are some photos.
All voltages are about 4% higher than the specs printed on the PSU.
5.2v
18.7v
25.0v
I replaced one bulged capacitor on the +24 output rail but it did not help.Attached FilesComment
-
-
Re: Olevia 237-T12 horisontal lines after 1 min
The backlight is not flickering as I can see it from the holes on the back.
And I really doubt it may cause that "image jumping".Comment
-
Re: Olevia 237-T12 horisontal lines after 1 min
OK I did a little bit of diagnostics.
When I press on the BGA chip on the mainboard the screen distortion reduces.
So I guess it is the main board.
Is there any way to fix?Comment
-
Re: Olevia 237-T12 horisontal lines after 1 min
You could try to heat the BGA ; see video
https://www.youtube.com/watch?v=XOpi3FbeqpYComment
-
Re: Olevia 237-T12 horisontal lines after 1 min
Baked the board for 8min on 375F and it works now!
here are some photos:Attached FilesComment
-
-
Re: Olevia 237-T12 horisontal lines after 1 min
HDMI ports still get the lines and jumping, and it looks like Digital TV went out. I only get analog channels now.Comment
-
Re: Olevia 237-T12 horisontal lines after 1 min
after 3rd bake attempt I just bought the new main board for $10 off ebayComment
-
Re: Olevia 237-T12 horisontal lines after 1 min
The seller I bought from had only one.
Just search by part numberComment
-
All left and right refers to looking from rear of TV (or looking from front with TV upside down)- TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
- Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
-
Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed... -
Hi all
I have lines on the screen...which is an age old problem that can be remedied by watching Youtube videos and getting out the tape.
My issue (after successfully fixing a different sammy tv with a separate tcon board and isolating the side of the panel...):
This tv has an integrated tcon...so it is a bit more confusing when trying to isolate the clocks.
It has a c ribbon and i have taken each end out to see if that will isolate the lines. instead, it makes it much worse ALL over the tv!
So....i don't know what end of the C ribbon to work with... -
Hello,
First of all I'm new here. While looking I found this amazing forum and I'm very happy I did. Now for my problem:
I picked up a Samsung UHD QLED QE50Q67TAU from 2021 for $50 knowing it was defective. The seller said it had black lines and that it could get stuck in boot randomly.
I've tried a new power cable, hard reset, opening up and jiggling all cables, pressing everywhere to see if I get a reaction but I've gotten nothing. I've tried the tape method but I've only managed to get the lines worse.
I'm no expert but I've done the tape... -
Hi, I have a Sony XBR-65X750D that has horizontal lines at the bottom 6 inches of the screen. These lines appear to be every other line because the picture is still quite visible behind those lines. The lines appear all the time with a few other lines above and below the 6 inch level blinking on and off at about 2 second intervals. I'm not sure if this is a panel issue or power supply/main board problem. I did replace the T-Con board without any change in the problem. Any suggestions you might have would be greatly appreciated. Thanks,
Comment