LG 60PA6500 - won't turn on

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • garfield-cat
    Member
    • May 2014
    • 12
    • Canada

    #1

    LG 60PA6500 - won't turn on

    I have an LG 60PA6500 that will not turn on.
    When I fisrt plug in the TV a relay clicks and the red led on the from comes on and then nothing. Nothing when pressing the power button or using the remote.

    I tested the power going to the Y and Z boards and got va and vs power reading as they should (vs = 205v and va=55v) but the 5v was only reading 2.6.

    I pulled the power board and bench tested it (nothing else connected to it) and when plugged in the relay clicked and have the same voltage readings (vs = 205v, va=55v, 17v=17v but 5v and stand-by =2.6).

    I am curious why this board is staying powered up on va, vs and 17v with no logic board or main board attached to it and why 5v and stand-by is only showing 2.6v

    I m not sure where to start with this one. Any help is appreciated. Thanks
  • maxvalutech
    Badcaps Veteran
    • Dec 2014
    • 804
    • australia

    #2
    Re: LG 60PA6500 - won't turn on

    I would test for the 5v from source to output connector to find where it drops then when 5v is at output th3 main should activate. Possibly resistor/s on the feed circuit gone a bit high.

    Comment

    • garfield-cat
      Member
      • May 2014
      • 12
      • Canada

      #3
      Re: LG 60PA6500 - won't turn on

      thanks. I have no idea where to tell where to find the "start" of the 5v. Any ideas?

      Comment

      • maxvalutech
        Badcaps Veteran
        • Dec 2014
        • 804
        • australia

        #4
        Re: LG 60PA6500 - won't turn on

        With standby on your power board is "idling" to save on electricity but there should be voltage around 160v as measured between two legs of big capacitors rated 450v. From that section the 5v is derived and when power on is executed this voltage signal is sent to main board which responds then to ps-on basically saying "Ok I'm good let's go" and the power supply then switches on all the other voltages. If your Va etc is on then the Ps-on must be picking up a voltage from somewhere on the power board. Try to find a schematic for that board by maker and model number of the board itself. Holding the board up to a light source eg sky you can sometimes see where what goes. If you are fairly certain the power board is faulty perhaps shopjimmy site may have a fixit kit or replacement. Here in Oz I usually look to China via aliexpress site. Pay the price and take your chances type of thing but at least plenty of compatible spares with two boards from which you may make up a good one if both had a problem

        Comment

        • garfield-cat
          Member
          • May 2014
          • 12
          • Canada

          #5
          Re: LG 60PA6500 - won't turn on

          Thanks .. I'll keep poking around and see what I can find out. I was thinking of ordering a new power board but wanted to be 90+% sure it was that before I dished out the cash for a new one.

          Comment

          • garfield-cat
            Member
            • May 2014
            • 12
            • Canada

            #6
            Re: LG 60PA6500 - won't turn on

            OK .. I decided to poke around a bit and display all the voltages. I really can't figure this one out and really need your help. EVERYTHING looks right and can't understand what is going wrong.

            The attached pictures show all the voltages on the connectors.

            As soon as I plug in the board when bench testing it the relay clicks and all voltages are present. With the board in the TV, the red light on the main board is on , the green light on the logic board flashes green and the light on the front of the TV is on (red) .. but the screen does not come on and all buttons on TV and remote do nothing.

            I am not sure about what I am suppose to have on connector P813 (with the error_det, ac_det, etc).

            Hoping someone can help as I don't want to buy a new power board if it is not the faulty board.

            Thanks
            Attached Files

            Comment

            Related Topics

            Collapse

            • pajdek
              Lenovo Y700-17ISK turn on and off
              by pajdek
              Hello, i have some issues with my laptop Lenovo Y700-17ISK (motherboard BY511 NM-A541), it started when i turn on the laptop, but the lcd wont turn on, i then connected it via hdmi to tv and screen was ok. So i thought maybe lcd stripe is faulty, i removed the bottom cover, disconnected main battery, reset the cmos by disconnecting battery for 1 min, then slighty move the lcd stripe. Conncted power supply and tuned on my laptop, the lcd turn on, it started to load os, then it turn off, after a second it turn on, then after like 3 seconds turn off again, and so on. Removed power supply, waited...
              09-20-2023, 02:49 AM
            • RdeveLabs
              MSI GF63 THIN 11UCX (MS-16R6) LAPTOP WON'T TURN ON AFTER RESTARTING
              by RdeveLabs
              To all the members here...

              Let me tell you a little bit about what happened to my laptop (MSI GF63 THIN 11UCX model: MS-16R6) that “maybe” you know how to solve this problem.

              So before this problem happened, my laptop was running smoothly. When I wanted to restart my laptop, it looked fine at first. But after I waited for this restart process to take a long time, until finally I panicked (because the restart process did not finish plus the laptop screen only showed a black screen), I immediately pressed and held the power button to force the laptop to turn off. But...
              05-05-2025, 04:59 AM
            • robante15
              Acer Aspire 4520 won't turn on after reboot
              by robante15
              Hello, I have an Acer Aspire 4520 from a couple of decades ago and I want to repair it solely for nostalgia.

              It happens that when I turn it on after having been disconnected for a long time, it turns on without problems, it tells me that the BIOS has been reset and that it will load the factory settings, if I tell it to continue, the computer turns on and everything works fine.

              The moment I turn it off and want to turn it back on a second time, or restart it and try to start it again, it no longer gives an image, and it no longer responds.

              If I remove the...
              04-06-2024, 06:50 PM
            • masoksian
              Dell latitude e7470 not turn on .power buton on off and Run Power problem
              by masoksian
              Hi everyone,

              I am dealing with the problem of turning on and off my Dell e7470 notebook.

              The battery charge light is solid white, I press the button, the power indicator and the light on the button are solid for 1-2 seconds and immediately turn off.

              The system does not turn on, there is no post.

              I removed the RAMs and changed them, changed the battery, RTC battery, AC adapter, removed them and waited, tried again, it does not turn on.
              The problem continues in the same way.
              I tried to turn on the Fn key, nothing came to the screen....
              02-15-2025, 12:08 PM
            • dqtech
              lenovo x240 nm-a091 wont turn on
              by dqtech
              i got this laptop with no power issue....i flashed the bios and laptop can turn on and use normally....but when i shut it down and rest for few minute (2-3 minutes), it wont turn on....i have to flash bios again...any idea what is the problem?...when i shutdown and suddenly press power button to turn on, it will turn on normally....problem happen when i rest the laptop 2-3 minutes after shutdown, it will not turn on....i need to flash bios again
              board number VIUX1 NM-A091 REV:1.0...
              02-07-2024, 01:57 AM
            • Loading...
            • No more items.
            Working...