Philips 32PFL3008H strange backlight problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • gurug
    Member
    • Mar 2015
    • 27
    • Slovenia
    #1

    Philips 32PFL3008H strange backlight problem

    Hello to all!

    I repaired philips 32pfl3008h last week, changed 4 diodes in power supply and fuse. TV started working again. But now I see that randomly after from 2 to 4 hours of tv on, backlight turns off... Sound plays on. After I switch tv off and on again, it works again for few hours...
    Can anyone point me in right direction what should I also check?

    Thanks in advance.
    Tags: None
    • gurug
      Member
      • Mar 2015
      • 27
      • Slovenia
      #2
      Re: Philips 32PFL3008H strange backlight problem

      Originally posted by gurug
      Hello to all!

      I repaired philips 32pfl3008h last week, changed 4 diodes in power supply and fuse. TV started working again. But now I see that randomly after from 2 to 4 hours of tv on, backlight turns off... Sound plays on. After I switch tv off and on again, it works again for few hours...
      Can anyone point me in right direction what should I also check?

      Thanks in advance.
      Problem solved, it was one LED not working in backlight...

        Comment

        Previous template Next

        Related Topics

        Collapse
        • janos6662000
          Philips 47PFS7509/12 LCD TV problem
          by janos6662000
          Hi

          I have here a Philips 47PFS7509/12 LCD TV which came to me with a weird problem : without signal i could access menu, make a factory reset, access menus, etc.
          When i applied cable signal to check image, i had normal picture, but TV was restarting.
          I downloaded original firmware and applied the update, but the problem remained.
          From a colleague i received a "factory package software" which is a lot bigger.
          I made another firmware update, but still did not solve the problem.
          Somewhere on the way the error got worse, because at the moment the...
          08-12-2025, 12:54 PM
        • chestercc
          Philips TV Backlight Repair
          by chestercc
          So i'm trying to replace the LED's in a Philips TV. It's 42" with a 715g7262-p01-000-0010 backlight driver board based around an O2 Micro OZ9902CGN.

          My issue is when I replace all the LED's on one board with the new 3V 300ma ones they immediately burn out when the set is powered again. I previously tried the same thing with 6V LED's and the backlight flickered for a bit but wouldn't start.

          The original LED's which I removed which are still working start to melt and burn when given more than 3V on DCPS so I know they shouldn't be higher voltage ones.

          ...
          11-18-2022, 01:15 PM
        • ohren
          Trying to control Philips backlight manually with PWM — brightness increases with frequency...?
          by ohren
          I raised the question of whether PWM on the power board "dim" pin would be a reasonable assumption for controlling the backlight of a Philips TV (55put6101/12): https://www.badcaps.net/forum/troubl...d-tv-backlight. I didn't receive any insights there so I went ahead and tried it.

          The setup is basically:

          Rpi3 hardware PWM → 220 Ohm → NPN transistor → dim pin

          Transistor is switching the 3.5 V supply on the power board....
          12-05-2024, 11:10 AM
        • Dobrowol
          Asus GA402RK keyboard and kb backlight problem
          by Dobrowol
          Hi. I have a problem with Asus ROG GA402RK. The keyboard suddenly stopped working along with the kb backlight. I replaced the keyboard and the ITE KBC chip and the problem is still the same. I don't see any passive elements that look damaged. Does anyone have an idea?
          04-28-2025, 04:30 PM
        • Xristakis795
          42pfl5405/h05 philips lcd tv backlight problem
          by Xristakis795
          Hi i have the above tv and has backlight problem
          I noticed with a flashlight that I have picture and sound when I put an antenna
          My problem is that I do not have a device to test the fluorescent lamps and extend the transformer high to see which of the two is to blame and to give a solution to my problem
          I was thinking an easier solution would be to turn the TV into a LED but I had done it before in another (different model) and it looked like bright dots behind the lcd panel and it was ugly
          What do you recommend ?
          07-04-2021, 03:39 PM
        • Loading...
        • No more items.
        Working...