Re: Sony KDL-50W656 vertical colored lines
Ok, I re-seated cables, but problem remains. Contacted some service here, they said it's possible t-con problem, t-con is not simple to replace, it's integrated on display board ... they said to deliver tv to them, and they'll see if it's repairable...
Thanks for help...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Sony KDL-50W656 vertical colored lines
Sony KDL-50W656 has colored vertical lines, they change color when getting into menus with remote, etc ...
What could be wrong, panel gone bad?
Regards...
-
Sony Bravia KDL-40HX720 - thin lines on top of screen
Hello,
can someone advise me, if this is panel failing or is it t-con problem. Black and white thin lines appeared on top 5cm of screen, look at attached picture.
Thanks in advance for all the help....
-
Re: Strange problem with Toshiba L775
I torn the laptop down again and checked mosfets, they all seems fine .. But interesting thing happened. I left laptop completely to dry out battery, and then suddenly started to work ok... until ... I took battery out and put it in again... is this bad battery symptom (I really hope so)?
EDIT: Did not work for a second time ... when it worked battery was long time showing 99% in windows when charging. Left it to run out of juice ... and computer worked ... But now it was showing 23% in windows, left it again to run...Last edited by gurug; 09-15-2016, 09:28 AM.
Leave a comment:
-
Strange problem with Toshiba L775
Diagnosis of my laptop power on problem:
Laptop is working fine with only charger. Also is working fine only on battery, but if I connect battery and disconnect charger after it's powered off it will start again only from battery. Trying to connect charger at that time will result in dead computer, no lights, nothing. Then I must remove cmos battery to get it working again.
I ordered new battery, but I'm afraid this won't do any good ...
Could somebody share opinion, what could be the problem? Is it a battery problem? How could I diagnose it further?...
-
Re: eax64905001 No Pfc Help ?
Problem SOLVED!
It was two LED's which were broken on backlight ... power supply does not output 70V if it detects problem with LED's ... So it was in protective mode. I replaced LED's and TV is working normally. Thanks for you help and ideas!
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
Hm, order "new" power supply board, but no luck ... seems this board I got is broken too ... It has 0V on LED output ... but I'm wondering, it is same model of board EAX64905001, but original was REV2.0 and this one I bought via eBay is REV4.0... Is this relevant?
Like I said before on old board when I disconnect MOSfet I got stable 46V on connector ... please advice me further where to look - mosfet seems ok ...
Thanks...
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
Tested q801 and it seems ok ... hm, I guess I'll just order new power supply...
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
I disconnected mosfet q801, and i got 46V on led connector and no fluctuation... does that mean that q801 is bad?
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
I thought your problem was only with MAP3202?
On mosfet middle pin gets 43 to 48V - from L801...
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
Can you tell me which mosfet you have in mind?...
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
I'm measuring C214 directly and LED connector also directly I use + and minus on connector......
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
Yes on connector is from 11 to 20V. And on C214 is like I said. And it's not going straight to connector, see attached schematics....
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
On C204 and C214 voltage is fluctoating from 43 to 48V ... if this helps to diagnose?...
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
PCB is same as listed on first page of this thread, I attached pictures. And also schematics of power supply....
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
Can you tell me which diode and mosfet is that? And what diws s/c mean? Voktages on connector to main board are all ok, 24v also....
Leave a comment:
-
Re: eax64905001 No Pfc Help ?
I have exactly same problem, voltage to backlight fluctoates between 11-20V. I replaced MAP3202 - but problem is the same ... can you help me to further diagnose fault?
Thanks in advance....
Leave a comment:
-
Philips 32PFL3008H strange backlight problem
Hello to all!
I repaired philips 32pfl3008h last week, changed 4 diodes in power supply and fuse. TV started working again. But now I see that randomly after from 2 to 4 hours of tv on, backlight turns off... Sound plays on. After I switch tv off and on again, it works again for few hours...
Can anyone point me in right direction what should I also check?
Thanks in advance.
No activity results to display
Show More
Leave a comment: