Soniq 42s12001

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • hispeck
    Badcaps Veteran
    • Aug 2015
    • 258
    • nigeria
    #1

    Soniq 42s12001

    Hey Guys, i have LG 42s1 am working on right now, the 197v and 65v vs and va volt comes up when i power the plasma without plugging ysus and zsus, but when i plug them the two voltage will shut down
    please can anyone help with a solution on how to troubleshoot it?
    HispecK
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • unimatrix93
      Inexive (Vestel) TV constantly blinking after plugging in
      by unimatrix93
      Hello everyone, I have a constantly blinking Inexive LED TV.
      Display is: VES390UNVA-2D-N01
      Mainboard: 17MB97​
      PSU: 17IPS71

      The TV power led start blinking constantly right after plugging it in, I tried to update via USB but did not help....
      03-26-2025, 08:36 AM
    • reessi
      LG Plasma ZSUS Flashing Screen, No Booting! - 50PB690V
      by reessi
      Replaced Zsus beginning of year as most transistors were short stopping tv powering up.

      Now screen flashes on off continually and ZSUS ticks. Looking like replacement maybe faulty or could something else cause it to shut down.

      If I remove both tabs from ZSUS to screen but keep all other connectors to ZSUS on then TV boots properly but screen very dark without ZSUS output, no ticking from ZSUS. So it only shuts down when under load from screen.

      If it is ZSUS then how to fault find, I already looked for shorts. No transistors shorted or caps and its...
      12-13-2017, 01:18 PM
    • alfredomfr1
      TV Plasma LG 60PN5000 ZSUS 15v missing
      by alfredomfr1
      All Voltages are OK except ZSUS 15v.
      YSUS board disconnected still 15v missing.
      ZSUS was replaced: 15v missing.
      Any help will be appreciated...
      04-29-2022, 11:26 AM
    • JohnML1975
      Soniq S55V14B-AU White vertical bar middle of screen
      by JohnML1975
      Hello Forum Team

      Have this issue
      Found signs of burning or some sort of build up of something on the flex cables that go between T-CON and screen buffer boards
      Tried cleaning the flex cables and the ports where they go in but the problem remains
      Swapped the flex cables but problem remains
      Cannot see anything burnt on the main board or the t-con board
      Checked for shorted capacitors on the buffer board and did not find anything

      Am going to try using sticky tape on one of the flex cables to and see if i can resolve
      09-27-2025, 02:55 PM
    • JohnML1975
      Soniq QSL422XTV2 - not standy light and will not turn on
      by JohnML1975
      Hello All

      Have this TV and just started working on it
      Removed back panel and cannot see obvious problem
      Used thermal camera and the boards appear to not have power going to them

      Discon M/B to PSU and fault did not change
      Did same with T-CON board and fault did not change

      Next I will check if there is power going to the T-CON and the LCD inverter boards and the Main Board M/B

      Thank you
      09-06-2025, 06:23 PM
    • Loading...
    • No more items.
    Working...