What would cause this , I'm thinking tcon but not sure I notice usb error also in box on bottom left. Sound works fine. And picture is present. Would firware update help when I go in current firmware boxes are blank.
Samsung ln55c630 rainbow lines vertically on whole screen
Collapse
X
-
Tags: None
-
Re: Samsung ln55c630 rainbow lines vertically on whole screen
Mainboard faultTELEFIX
How PLASMA SCREENS WORK, X-SUS and Y-SUS what they do--
http://www.irf.com/technical-info/appnotes/an-1088.pdf
PLEASE DO NOT EMAIL ME PRIVATELY FOR REPAIR ADVICE. QUESTIONS BELONG ON THE FORUM! -
Re: Samsung ln55c630 rainbow lines vertically on whole screen
check under light all USB PORTS IF THERE ONE BROKEN AND MAKE SHORT CONTACTComment
-
Re: Samsung ln55c630 rainbow lines vertically on whole screen
Flexed and tapped main board at lvds connector and screen clears up to a perfect picture any ideas to get it to stay, need u.s. fix alsoComment
-
Re: Samsung ln55c630 rainbow lines vertically on whole screen
LVDS connector had nothing to do with usb error, it may when you taped the eeprom lost connection got tight.Comment
-
Re: Samsung ln55c630 rainbow lines vertically on whole screen
It still is not fixed but when I put pressure on lives cable at main board it fixes. How can I make lives connection tighter its the flip close connection. Seems like I seen a scotch tape trick before.will firmware update fix usb problem or should I try to get another mainboardComment
Related Topics
Collapse
-
by howardc64All left and right refers to looking from rear of TV (or looking from front with TV upside down)
- TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
- Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
-
by Stanley1843Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
-
Channel: Troubleshooting Computer Displays
-
-
by jeyoung12Hi all
I have lines on the screen...which is an age old problem that can be remedied by watching Youtube videos and getting out the tape.
My issue (after successfully fixing a different sammy tv with a separate tcon board and isolating the side of the panel...):
This tv has an integrated tcon...so it is a bit more confusing when trying to isolate the clocks.
It has a c ribbon and i have taken each end out to see if that will isolate the lines. instead, it makes it much worse ALL over the tv!
So....i don't know what end of the C ribbon to work with... -
by RubenlilyHello,
First of all I'm new here. While looking I found this amazing forum and I'm very happy I did. Now for my problem:
I picked up a Samsung UHD QLED QE50Q67TAU from 2021 for $50 knowing it was defective. The seller said it had black lines and that it could get stuck in boot randomly.
I've tried a new power cable, hard reset, opening up and jiggling all cables, pressing everywhere to see if I get a reaction but I've gotten nothing. I've tried the tape method but I've only managed to get the lines worse.
I'm no expert but I've done the tape... -
by ggil44Hi, I have a Sony XBR-65X750D that has horizontal lines at the bottom 6 inches of the screen. These lines appear to be every other line because the picture is still quite visible behind those lines. The lines appear all the time with a few other lines above and below the 6 inch level blinking on and off at about 2 second intervals. I'm not sure if this is a panel issue or power supply/main board problem. I did replace the T-Con board without any change in the problem. Any suggestions you might have would be greatly appreciated. Thanks,
- Loading...
- No more items.
Comment