Bush s642f factory reset

[Rickig]

Finally got the set powered up but it won't tune.
It stays on atv 901. Checked the locks and all off so want to try a factory reset but can't figure it out.
Any body know how to do a factory reset on a bush?

[Rickig]

Re: Bush s642f factory reset

Managed to do a factory reset but still not finding any freeview.
Any suggestions

[jczarniak]

Re: Bush s642f factory reset

Managed to do a factory reset but still not finding any freeview.
Any suggestions

Hi,
I've got same TV and same problem.
Did you managed to fix it?

[jczarniak]

Re: Bush s642f factory reset

Hi,
I've got same TV and same problem.
Did you managed to fix it?

How to do factory reset, please?

[jczarniak]

Re: Bush s642f factory reset

Managed to do a factory reset:
MENU, 8, 8, 9, 3
but still not finding any Freeview channels.
Any suggestions?

[dick_barton]

Re: Bush s642f factory reset

Is it scanning for channels and saying none found?

[jczarniak]

Re: Bush s642f factory reset

Is it scanning for channels and saying none found?

Exactly, 0 channels found.

[dick_barton]

Re: Bush s642f factory reset

Have you checked the voltages on the tuner? It may have lost it's supply.

[jczarniak]

Re: Bush s642f factory reset

Have you checked the voltages on the tuner? It may have lost it's supply.

Not sure how can I do that.
Recently changed 4 caps on power supply (4 x 470uF/35V), screen backlight was flickering. OK now but no Freeview.

[dick_barton]

Re: Bush s642f factory reset

Does it have both an analogue and Digital tuner. If so are you auto tuning the Digital channels

[jczarniak]

Re: Bush s642f factory reset

Does it have both an analogue and Digital tuner. If so are you auto tuning the Digital channels

Has got both tuners.
I'm auto tuning both, tried separately also.
Result is 0 channels found for both tuners.

[dick_barton]

Re: Bush s642f factory reset

Have you got a schematic?

Can I assume that all the other inputs are working?

Does it say "XX Channels found" but just not storing them?

[jczarniak]

Re: Bush s642f factory reset

No schematic.
All inputs are working.
It say: 0 Channels found

[dick_barton]

Re: Bush s642f factory reset

Can you guarantee that you have a strong signal from your aerial. Have you plugged the aerial into another set to be certain it's not an aerial/aerial cable fault.

[jczarniak]

Re: Bush s642f factory reset

Yes, aerial is fine, working absolutely fine on other TV.

[dick_barton]

Re: Bush s642f factory reset

Can you supply a sharp photo of the power supply connector showing any legend alongside giving the voltages read.

Can you also supply a photo of the main board.

[dick_barton]

Re: Bush s642f factory reset

There appears to be a 5V regulator feeding the tuner and several metal oxide resistors around the tuner you could check out.

[jczarniak]

Re: Bush s642f factory reset

There appears to be a 5V regulator feeding the tuner and several metal oxide resistors around the tuner you could check out.

Good idea.
I'll check that.