TV COBY LEDTV5536 Horizontal lines

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • alfredomfr1
    Badcaps Veteran
    • Oct 2014
    • 318
    • usa

    #1

    TV COBY LEDTV5536 Horizontal lines

    Hi
    T-Con board or bad panel?
    Thanks
    Attached Files
  • ReeceyBurger123
    Never Give Up !
    • May 2014
    • 7325
    • Britain

    #2
    Re: TV COBY LEDTV5536 Horizontal lines

    I would say panel.
    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

    https://www.facebook.com/Telford-Tel...7894576335359/

    Comment

    • alfredomfr1
      Badcaps Veteran
      • Oct 2014
      • 318
      • usa

      #3
      Re: TV COBY LEDTV5536 Horizontal lines

      How do I test a t-con board, because if the panel is bad the tv is garbage

      Comment

      • ReeceyBurger123
        Never Give Up !
        • May 2014
        • 7325
        • Britain

        #4
        Re: TV COBY LEDTV5536 Horizontal lines

        A Tcon wont cause that failure all it does is decode the Lvds signals, so its either your Mainboard or more than likely Lcd panel.
        Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

        https://www.facebook.com/Telford-Tel...7894576335359/

        Comment

        Related Topics

        Collapse

        • advant
          Driving a Sharp TCON/panel with a universal main board
          by advant
          This thread is about trying to get an Universal Main Board to work with a Sharp TCON and panel.

          I have a Sharp LC-46D85UN TV that has had a main board issue. Since this model is from 2009, I am not able to find an exact replacement of the main board. Instead, I decided to see if I can future proof this tv by getting a Universal Main Board (T53U21.2) from China to work with the Sharp TCON (CPWBX4291TPZA) and panel. The universal main board supports a 8 bit dual channel LVDS interface whereas the TCON requires a 10 bit dual channel LVDS input. I have modded the LVDS connector to match...
          02-03-2020, 12:25 AM
        • Sharx112
          ASUS VA27EHE randomly unstable
          by Sharx112
          Hello community. I've got an ASUS VA27EHE with a Panda LC270lf1l01 panel that started to behave strangely. A bit of intro:
          If you power on the monitor without any inputs it turns on, displays the ASUS logo, shows no signal and goes into standby normally. When you plug it via HDMI sometimes and more recently, most of the times, it distorts the bios logo with horizontal lines, then when loading into windows 50-50 the windows emblem also is in horizontal lines. And after the system loads it almost always works properly, lol. On some rare occasions a part in the top of the monitor is being distorted...
          03-26-2025, 03:42 AM
        • mmartell
          General Questions on the Relationship Between Mainboard, TCON and Panel
          by mmartell
          My goal here is to be able to use boards on hand to swap into faulty sets when the faulty board is not obvious.

          I will start by asking what is the format of the output from the mainboard and is it generic in any way or does it vary by manufacturer and/or model ?

          And as far as I know a tcon and panel must be a matching pair because the timing of the signals and the voltages required to drive the panel are specific to the panel itself. (That may be a blanket statement that isn't true in some cases where the panel creates its own sub-voltages on its panel boards?)...
          01-06-2024, 01:32 PM
        • Kikerumbo
          Mi Curved Gaming Monitor 34" - Horizontal lines
          by Kikerumbo
          Hello everyone,

          Thanks in advance for any help you can provide.

          I have a Mi Curved Gaming Monitor 34". A few weeks ago it started to show (or not showing) horizontal lines. Of course, it's outside of the warranty period.

          After some hours of reading and watching videos I disassembled the monitor and checked the ribbons that go from the TCON board to the panel PCB. If I disconnect the ribbon for the right side of the panel, the other half shows a perfect image. I ordered a "new" TCON, installed it and the issue persists so that tells me it must...
          03-14-2024, 02:48 PM
        • Lee M.
          Amazon Fire TV Omni K24NE5 tcon or panel bad?
          by Lee M.
          TV came on with BL on but blank screen. Disconnected one of the ribbon cables from tcon to panel driver board and now I have half of the screen working normally. Any way to tell if the problem is with the tcon or the panel driver board or the panel itself? Should I just replace the tcon and see what happens?
          05-12-2023, 05:47 PM
        • Loading...
        • No more items.
        Working...