LG 60" 60pv250 sound but no picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • eliteconcept
    Member
    • Apr 2011
    • 16

    #21
    Re: LG 60" 60pv250 sound but no picture

    I did a quick test, DID NOT PLUG the buffers back into the y-sus.
    The led on the control board did 3 quick flashes, and one slow flash

    Comment

    • eliteconcept
      Member
      • Apr 2011
      • 16

      #22
      Re: LG 60" 60pv250 sound but no picture

      Originally posted by Hamie
      Out of interest is the control board LED blinking once every six seconds?
      Heres what I found

      With and without the buffers plugged in to the y-sus the control board led does the same thing. 3 fast blinks and 1 slow blink.

      Comment

      • Hamie
        Badcaps Legend
        • Apr 2014
        • 1383
        • UK

        #23
        Re: LG 60" 60pv250 sound but no picture

        Ok I believe it should blink once every 2 seconds.

        Can you confirm one of your posts earlier you said zbias should be 110, and it only reached 1 volt? Or do you mean it reached 110 then dropped off?

        Would be strange (but not impossible) for both the y-sus and z-sus to both be faulty considering they are separately linked through the power supply.

        Comment

        • tom66
          EVs Rule
          • Apr 2011
          • 32560
          • UK

          #24
          Re: LG 60" 60pv250 sound but no picture

          Hamie... isn't that just for Samsung sets?
          I think the LG LED is only blinking according to panel temperature in some kind of morse-like scheme.
          Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
          For service manual, schematic, boardview (board view), datasheet, cad - use our search.

          Comment

          • eliteconcept
            Member
            • Apr 2011
            • 16

            #25
            Re: LG 60" 60pv250 sound but no picture

            Originally posted by Hamie
            Ok I believe it should blink once every 2 seconds.

            Can you confirm one of your posts earlier you said zbias should be 110, and it only reached 1 volt? Or do you mean it reached 110 then dropped off?

            Would be strange (but not impossible) for both the y-sus and z-sus to both be faulty considering they are separately linked through the power supply.
            I tested again both with having the leads right on the test point when the tv is turned on and after it is turned on. in both cases the reading started off at or around 0 then slowly ramped up to about 1.

            Comment

            • eliteconcept
              Member
              • Apr 2011
              • 16

              #26
              Re: LG 60" 60pv250 sound but no picture

              Does this mean that both ysus and zsus are bad?

              Comment

              • MVC
                Member
                • Jul 2015
                • 33
                • USA

                #27
                Re: LG 60" 60pv250 sound but no picture

                My 60PV450is same basic set. And it now seems that both Y & Z Sustain boards are bad.

                I have come to the conclusion that these sets were right on the edge, a little push and down they go.

                Comment

                • Bad60pv250
                  New Member
                  • Sep 2016
                  • 1
                  • United States

                  #28
                  Re: LG 60" 60pv250 sound but no picture

                  My lg 60pv250 just lost picture but has sound trying to figure it out aswell i orderd a new powerboard thinking that would fix it but the board i received via ups was cracked. And now im back at step one any suggestions?

                  Comment

                  Related Topics

                  Collapse

                  • TR103
                    Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
                    by TR103
                    Hi, I have a Samsung UE50TU with:
                    - sound and backlight, but no picture
                    - when it arrived, it had a picture for a few seconds
                    - it keeps rebooting
                    - without ribbon cable between the two panel boards, it does not reboot but I have no picture
                    - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
                    - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

                    - without cable between mainboard and lcd panel and with a jumpered...
                    01-22-2025, 04:12 PM
                  • Mgiffune
                    Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
                    by Mgiffune
                    I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

                    I ordered a supposedly ‘new' Tcon board this time, and
                    ...
                    06-09-2024, 10:28 AM
                  • Ierwin
                    Samsung UE60KU6079 backlight okay mainboard responsive, no picture, no sound
                    by Ierwin
                    Hello everyone,
                    Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
                    The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
                    He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
                    I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
                    Anyway I still fully expect that there has been something seriously damaged...
                    05-13-2025, 03:31 PM
                  • jchang
                    Samsung UN70NU6900F no picture and no sound
                    by jchang
                    Hi all

                    I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.



                    Symptom:
                    No picture no sound.
                    When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
                    No sound at all.



                    What I tried:
                    1. I tried unplugging the left or right ribbon...
                    01-09-2023, 06:28 PM
                  • ChaosLegionnaire
                    what i went through dealing with my mobo with dead onboard sound!
                    by ChaosLegionnaire
                    so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!! what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol!

                    i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...
                    09-13-2022, 09:02 AM
                  • Loading...
                  • No more items.
                  Working...