Is this normal? Sony KDL-V40XBR1

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • savageone
    Member
    • May 2015
    • 14
    • USA
    #1

    Is this normal? Sony KDL-V40XBR1

    The attached pictures (front and back view) are of the T-con board from my Sony Bravia KDL-V40XBR1. On the top side there is a silicone like grease oozing from some of the components and on the corresponding back side there are some high temperature markings.

    The angle of the board had to be just right for the markings to show up in the pictures. Is this confirmation of a defective T-con board?
    Attached Files
    Last edited by savageone; 05-18-2015, 03:05 PM.
    Tags: None
    • savageone
      Member
      • May 2015
      • 14
      • USA
      #2
      Re: Is this normal? Sony KDL-V40XBR1

      Thermal paste. Probably normal. This is fun!

        Comment

        • newtothis
          Badcaps Legend
          • Mar 2013
          • 1556
          • england
          #3
          Re: Is this normal? Sony KDL-V40XBR1

          That looks like flux and heat marks from an IC replacement but was never cleaned up.

          Ok what are your symptoms and give us clear pictures of all boards and layout.

            Comment

            • newtothis
              Badcaps Legend
              • Mar 2013
              • 1556
              • england
              #4
              Re: Is this normal? Sony KDL-V40XBR1

              Please don't start a new thread for the same Set,

              Can a Mod remove this please and we will carry on with the main thread

                Comment

                Previous template Next

                Related Topics

                Collapse
                • beetle1303
                  Sony KD-65X7000E - Screen double images for first few minutes then back to normal
                  by beetle1303
                  Hi,
                  I have gotten this Sony KD-65X7000E TV completely dead. According to owner TV was working fine and suddenly blackout and not able to power on again.
                  Checked and found D751 rectifying diode shorted, replaced and now power up and working almost normally:

                  1) On power up - display double images, and flicker once every few seconds.
                  2) After 3-4 minutes at this state - display suddenly back to perfectly normal (although there are few horizontal lines at the bottom of screen).
                  3) Leaving on for few minutes, power off and on again will repeat the same...
                  03-11-2023, 02:07 AM
                • Carlos#2003%
                  Schematic de una Sony VAIO PCG-41217u, Sony VPCSB45FL (MBX-237), 1p-0117j01-a012 mbx-237.
                  by Carlos#2003%
                  Buenas mi nombre es carlos me uni al foro porque estoy buscando el schematic de una sony vaio pcg-41217u otras formas de escribirlo son 1p-0117j01-a012 mbx-237 numero de placa revision 1.2 o Sony VPCSB (MBX-237), en fin me gustaria y ayudaria un monton si alguien me puede dar dichi svhematic para hacer las mediciones de una laptop de la mencionada anteriormente(Sony VAIO PCG-41217U) con el fin de repararla dejo de funcionar solo prende el led de la bateria al pulsar el boton de power el disco empiesa a hacer ruido de actividad pero los leds del frontas no reflejan acividad y no enciende la pantalla....
                  02-15-2024, 07:52 PM
                • dkneyle
                  Sony KDL-46HX850 Can't upgrade/update firmware
                  by dkneyle
                  Diagnosed this TV as having a failed main board which I've replaced with one from a KDL 55HX850. They are (supposedly) the same board.

                  Being 'Smart TV' it requires a firmware reboot when you swap out boards such as T-Con or main board. It starts with a black screen and flashing yellow and green LEDS, indicating it needs that firmware boot. The procedure described all over the web is to put the software into the root directory of a FAT32 formatted USB drive and it should load that up once plugged into USB1 port. But not for me. I can see the LED on the USB chip flash for about...
                  09-25-2024, 10:44 PM
                • Document Archive
                  Sony VAIO SVF11N1L2E Hybrid (2-in-1) Fit multi-flip Specification for Upgrade or Repair
                  by Document Archive
                  This specification for the Sony VAIO SVF11N1L2E Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the SVF11N1L2E boardview and SVF11N1L2E schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...
                  09-06-2024, 05:27 AM
                • Instafixx
                  Macbook A2179 820-01958
                  by Instafixx
                  Hi,
                  Have a Macbook A2179 with liquid damage. Customer showed it some shop which has done an ultrasonic cleaning of the board.
                  The board pulls 0V but doesnt turn on. No Fan SPIN. NOT IN DFU.

                  I checked the Power Sequences below and found this -


                  Once a valid external power source (Charger or battery) is connected, the following rails will come online.
                  PPBUS_G3H: Normal voltage is ~12.6v on the charger with the battery disconnected. Produced from the ISL9240 (U7000, which uses PPDCIN_G3H as its VIN.
                  PP3v3_G3H_RTC: Normal voltage is ~3.3v. Produced...
                  05-20-2023, 05:19 AM
                • Loading...
                • No more items.
                Working...