40 inch philips lcd tv model # 40pfl3705d/f7 no picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • christo
    Member
    • Jan 2015
    • 25
    • canada

    #1

    40 inch philips lcd tv model # 40pfl3705d/f7 no picture

    No picture, uncertain of sound because I do not have a remote with the tv to switch inputs ( or try to anyway)


    backlight does come on, its brightens at first then dims but is on.

    I toggled the ribbon cable on the t-con board to try and get a difference but no such luck, just blank screen.

    also makes a buzzing/hissing noise hard to describe, only happens when its on.
    Attached Files

    if you find these attachements useful please consider making a small donation to the site

    Last edited by christo; 01-13-2015, 08:19 PM.
  • capkid
    Badcaps Legend
    • Oct 2010
    • 1339
    • United States

    #2
    Re: 40 inch philips lcd tv model # 40pfl3705d/f7 no picture

    Do a continuity test on the t-con fuse.

    Edit: I had the same issue a couple years ago with this particular TV. I soldered a new fuse on top of the old one instead of trying to remove it - totally acceptable: http://www.digikey.com/product-detai...5TR-ND/1206513
    Last edited by capkid; 01-17-2015, 12:03 PM.
    LG Plasma Mal-Discharge Correction Service

    Comment

    Related Topics

    Collapse

    • Patrick501
      Philips 55PUS6704 no picture, backlight ok
      by Patrick501
      Hello,
      I'd like to repair a Philips 55PUS6704.
      It turns on and you can see the backlight, hear the sound but no picture.

      When I disconnect one of the T-con cables, half of the screen turns white.
      right cable disconnected= right side white
      left cable disconnected= left side white

      When I tape like 6 or 7 pins of one cable it looks like the picture attached. I already tried another T-con board without success.
      There are no shorts on the the mainbaord and the two lcd panel boards...at leat I couldn't find any.
      Also you can notice one single...
      11-12-2025, 08:46 AM
    • Rauni
      Philips 58PUS7805/12 showed no picture; after T-Con replacement, shows halo
      by Rauni
      Hello, this is my first post on this forum, and my first attempted to repair a TV.

      My Philips 58PUS7805/12 stopped working recently. It is not that old, about 5 years. We were on a trip for a few days and when we came back, it had stopped working out of a blue (Perhaps our house was hit by a lightning strike? Don't know.)

      Read from a guide that I should test if the screen shows picture with one of the T-Con cables disconnected. Did that, it showed perfect picture (first on left, later on right side).

      Read also that we should test what happens if we...
      10-01-2023, 12:06 AM
    • Schwoin
      Philips 243v5lhsb00 Monitor Picture too bright
      by Schwoin
      Hey everyone,

      the picture on my philips monitor looks way too bright so that black appears grey and colors also seem too bright.



      While i tried to tilt the screen a little bit while it was displaying a picture, i´ve noticed, that there appeared some purple pixels. In the following picture
      you can see them on the top half of the photo.



      At a certain point during the tilting, the picture looked normal again but as soon as i laid it back down, the purple pixels were gone and the picture was bright again.
      ...
      03-21-2023, 12:40 PM
    • madyoyo
      Philips 37pfl560: Yellow picture
      by madyoyo
      HI.

      I have a weird problem with an old Philips 37pfl560 TV i put out of storage: the picture have a noticeable yellow hue, and its not caused by the settings (did a factory reset). I've never seen this before. I will try to get a photo with a real camera, with my phone its hard to see because of automatic white balance, but in real live the whites are really yellow.

      Anyone have an idea of what can cause this? Can CCFL tubes get "warmer" with time? This tv have several analog inputs,so its nice for retrogaming....
      05-30-2025, 10:16 AM
    • charlesdutcher
      No picture issue in Philips Chassis FTL2.1
      by charlesdutcher
      Hello,
      My Plasma Philips 37inch chassis FTL2.1 does not show picture. It automatically goes into protection mode after 30 seconds (red led blinks at 3Hz)


      Is there someone having any symptom like this? How to fix it?

      Thanks in advance!​
      08-06-2024, 09:55 PM
    • Loading...
    • No more items.
    Working...