Re: samsung LN-S4051D diagnal lines
I think I messed something up earlier, I was trying to test voltages on that mosfet with tv on, had a probe on neg. of bridge rec. and when I touched drain or source it was one of them, then the backlights went out, now they won't come back on even after heating that small section like before, but the damn thing did quit clicking every 5 seconds.
samsung LN-S4051D diagnal lines
Collapse
X
-
Re: samsung LN-S4051D diagnal lines
ok, shorted all 3 legs, it's 197 ohms drain to source.Leave a comment:
-
Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
think i found a bad mosfet, QI802, read funny, took it out, getting 192 ohms from drain to source, isn't that way too low?Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
PFC (Power Factor Correction) does not work.Attached FilesLeave a comment:
-
Re: samsung LN-S4051D diagnal lines
seem to have a strange reading on bridge rectifier, when tv backlight is on the dc voltage on the outer 2 pins are 106 volts, where I think it should be around 160, all diodes of bridge rec. read correct and inner 2 legs are 120 ac as expected, any thoughts on why the voltage is low?Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
well this one crapped out again, getting the clicking of the relay every 5 seconds, fixed it once with electro caps replacement and reflow of solder joints, lasted a few months now its back same thing, clicks every 5 seconds. When powerboard is unhooked from mainboard clicking stops but backlights don't come on, when heating area of ics801 for a minute or two tv comes on for 15 minutes or so no clicking, replaced or checked all caps and resistors in that area, anyone know if heating ics801 is making it work for that 15 minutes or should heating it have no effect on the ic as in letting the tv work for that 15 minutes??: sj pic of powerboard: https://www.shopjimmy.com/samsung-bn...ight-inverter/Last edited by nomoresonys; 06-02-2022, 02:56 PM.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
been checking these ics, the readings seem funny, ic101 from top=1.79v left=2.8mv right=3.34v. ic102 top=2.7mv left=13.3v right=7.9v. ic1702 top=starts at 22 mv keeps going up, left=3.7mv right=5.09v, middle=2.5v, which I thought the middle should equal the top, seems like one or all of these are messed up, thinking this might be causing my snowy picture, any ideas?, thanks.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
from reading, I think a snowy picture is caused by a bad IC or eeprom?Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
some places say it will, some say it won't, dunno?Leave a comment:
-
-
Re: samsung LN-S4051D diagnal lines
the panel # is LTA400WT-L01, sticker on mainboard # BN94-01091B, wondered if anyone has had success using a mainboard with a different number, BN94-01091A or BN94-00864A, for example, Thanks.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
cooked it again, no difference, read about somehow shorting the eeprom, then resetting in menu but cant get a menu up, because pic. is too snowy.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
putting this one on the back burner, out of ideas.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
http://assets.shopjimmy.com/media/ca...01370d-top.jpg, anyone know where the test points are on these, thanks.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
cooked it at 400 for about 15 minutes no dififference.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
yeah, I guess the only thing left to do is cook it, was hoping it would be an easy component to switch out, thanks.Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
its most likely a bad connection under one of the main IC's on your mainboard. BGA style which means ball grid array. Try meeting of the Board like I have done in an oven at 385 degrees for 10 minutes but suspect buying a new mainboard. are you confident you getting proper output voltages from power supply?Leave a comment:
-
Re: samsung LN-S4051D diagnal lines
wish I could find a service manual for this, electrotanya's training manual is pretty useless.Leave a comment:
Related Topics
Collapse
-
This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-07-2024, 05:50 AM
-
ALL LCD LED TV SERVICE MENU CODES
Service Menu Code with Board Name
China Universal Board / Jumper Board Service Menu Code
Changhong Ruba Service Menu Code
Ecostar LED TV Service Menu Code
Orient LED TV Service Menu Code
Haier LED TV Service Menu Code
TCL LED TV Service Menu Code
Samsung LED TV Service Menu Code
LG LED TV Service Menu Code
Videocon LED TV Service Menu Code
Supra LED TV Service Menu Code
Toshiba LED TV Service Menu Code
Symphony LED TV Service Menu Code
Veste/ LED TV Service Menu Code...-
Channel: Schematics and Boardviews
10-31-2024, 03:58 AM -
-
by RubenlilyHello,
First of all I'm new here. While looking I found this amazing forum and I'm very happy I did. Now for my problem:
I picked up a Samsung UHD QLED QE50Q67TAU from 2021 for $50 knowing it was defective. The seller said it had black lines and that it could get stuck in boot randomly.
I've tried a new power cable, hard reset, opening up and jiggling all cables, pressing everywhere to see if I get a reaction but I've gotten nothing. I've tried the tape method but I've only managed to get the lines worse.
I'm no expert but I've done the tape... -
by jeyoung12Hi all
I have lines on the screen...which is an age old problem that can be remedied by watching Youtube videos and getting out the tape.
My issue (after successfully fixing a different sammy tv with a separate tcon board and isolating the side of the panel...):
This tv has an integrated tcon...so it is a bit more confusing when trying to isolate the clocks.
It has a c ribbon and i have taken each end out to see if that will isolate the lines. instead, it makes it much worse ALL over the tv!
So....i don't know what end of the C ribbon to work with... -
This specification for the Samsung Galaxy Book Ion NP950XCJ Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the NP950XCJ boardview and NP950XCJ schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-06-2024, 11:40 PM
- Loading...
- No more items.
Leave a comment: