Element ELEFW502 New power supply and still no stand by light or turn on

[budm]

Re: Element ELEFW502 New power supply and still no stand by light or turn on

OK, If I follow it correctly.
If you look at the regulator with the big tab up.
The left pin (pin ) is the ADJ pin.
Middle pin which is also connected to the tab internally (pin 2) is the output pin, the voltage on this pin should be = to 1.25 Vref + the Voltage reading on pin 1.
Right pin (pin 3) is the Input pin.

[johnboy1313]

Re: Element ELEFW502 New power supply and still no stand by light or turn on

Did you get it working? I have one with a cracked screen to part out.

[waynewebb77]

Re: Element ELEFW502 New power supply and still no stand by light or turn on

Yes I did get out working,I ordered the voltage regulators from digikey changed out one and had been working like charm! Thanks to budm for the support!