I checked all the fuses. i have no voltage on the secondary side at all. i replaced ic601 which is for the 5 volt standby section but still didn't fix it. i have 170v across the main caps and 19v on the vcc pin of ic601. i thought then it might be r613 was bad but with it out of circuit it read 333k ohm which it is suppose to be a 330k ohm resistor so thats not it atleast i don't think so. i have 170v on 1 side of that resistor and about 256 on the other side where the drain comes off ic601. i checked all the diodes and caps and they seem fine on both the primary and secondary sides. i also checked the opto's and d631 which also seems fine.i did see that shopjimmy did have a repair kit but they are out of stock. maybe ic602 is bad but i don't know how to check it. i'm stumped any help would be appreciated. here is the schematic compliments of tom66. if pics are needed i will take some but hopefully we can figure it out with the schematic cause my camera sucks. page 43 has the schematic diagram.
[SM].pdf&mfg=Sanyo
[SM].pdf&mfg=Sanyo
Comment