I have the above model television, I received it third band from a friend when it began failing to power up. After some research, I replaced the caps on the power supply board, and the tv worked fine for about six months. Yesterday I received an HDMI switch with Toslink output to finally hook up all my devices to my surround sound. (The Toslink out on the TV itself has not worked since day one).
After setting up the switch, and getting everything to work properly, I watched tv for about 30mins then I had to go to work. I powered all the equipment down, and went to work. When I returned home, the only image I had on the TV was a pink square in the center. I reset the power to the system, and now anything put through the HDMI results in either a No Signal message, or a black screen. (Screen is lit, just blank)
I have removed the switch from my setup, but even if I input the HDMI signal directly from my system into the tv, I still have the same problem. Is this something with the HDCP? Or is the port fried? The board the HDMI is on also contains the analog inputs, and they work fine. I tested my system on another tv, and they work fine there, so I have isolated it to the inputs here.
After setting up the switch, and getting everything to work properly, I watched tv for about 30mins then I had to go to work. I powered all the equipment down, and went to work. When I returned home, the only image I had on the TV was a pink square in the center. I reset the power to the system, and now anything put through the HDMI results in either a No Signal message, or a black screen. (Screen is lit, just blank)
I have removed the switch from my setup, but even if I input the HDMI signal directly from my system into the tv, I still have the same problem. Is this something with the HDCP? Or is the port fried? The board the HDMI is on also contains the analog inputs, and they work fine. I tested my system on another tv, and they work fine there, so I have isolated it to the inputs here.
