Sony XR-55X90J 4 blinks

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Nicktronic
    Badcaps Veteran
    • Mar 2023
    • 247
    • Canada

    #1

    Sony XR-55X90J 4 blinks

    Hey guys, got this Sony that turns on momentarily and then goes black with 4 blinks of the standby light. I can't find a service manual, but best guess was the Local Dimming board based on a similar TV saying LD_ERR or BCM_ERR. I found a replacement, but it didn't work. Before I put more money into replacement boards, Im wondering if anybody has seen this issue and what worked for them, or has the service manual for this specific TV.

    Thanks!
    Attached Files
  • EazyBone
    Badcaps Legend
    • Jun 2023
    • 1317
    • United states

    #2
    Look for nicks tvs video on YouTube where he takes out the BL err pin and grounds it to the chassis. Maybe you'll find the problem goes away and or you can see a dead led in the set.

    ​​​​​Need a closer picture on the legend for PSU. This isn't a OLED is it?
    Last edited by EazyBone; 02-15-2024, 09:48 PM.

    Comment

    • Nicktronic
      Badcaps Veteran
      • Mar 2023
      • 247
      • Canada

      #3
      It's not an OLED. Tried what you/Nick's suggested, i grounded out the BL-ERR pin (pin 1 on my power supply board), but no luck. I pulled pin 1 wire from the connector on the power supply board and grounded it to chassis with a jumper. Originally, I saw that when the TV fails, the BL-ERR jumps up in voltage, but doesn't latch. So don't think it's my backlights.....or at least not the same problem as in the video.

      Comment

      • Nicktronic
        Badcaps Veteran
        • Mar 2023
        • 247
        • Canada

        #4
        Close up of the power board connector pinout

        Comment

        • lotas
          Badcaps Legend
          • Jan 2016
          • 4573
          • Russia

          #5
          4x - code error
          Attached Files

          Comment

          • Nicktronic
            Badcaps Veteran
            • Mar 2023
            • 247
            • Canada

            #6
            Ok, is there a troubleshooting procedure? Looks like T-Con according to your attachment. What do you mean by code error? Software?

            Comment

            • lotas
              Badcaps Legend
              • Jan 2016
              • 4573
              • Russia

              #7
              The chassis is the same as yours, here is the service manual and the procedure for dealing with errors
              https://www.manualslib.com/manual/20...page=38#manual

              Comment

              • Nicktronic
                Badcaps Veteran
                • Mar 2023
                • 247
                • Canada

                #8
                Ok, so the BE_LD_RDY (CL5223) voltage was low, so I guess it's the Main Board since it's not an OLED and I already replaced the Local Dimming board?

                Comment

                Related Topics

                Collapse

                • AK_777
                  Sony KD-65A1 Repair – 4 Red Blinks Error
                  by AK_777
                  Hi everyone!
                  I have a Sony KD-65A1 TV with a fault – 4 red LED blinks. After disassembly and visual inspection, I found that the G76 power board and DKA board had been replaced. It is also possible that TCON was replaced, but I am not sure – there are a few marker marks that could be factory-made.

                  Based on assumptions, the previous service attempted to solve the issue by replacing potentially faulty components. I decided to investigate further, found a service manual, and figured out a way to power up the power supply unit autonomously and put the OLED panel and...
                  02-20-2025, 04:15 PM
                • jchon
                  Sony A1e 5-blinks help
                  by jchon
                  Hi I'm new to trying to repair TVs, but I saw a broken OLED offered for a reasonable price and thought I'd try my hand at it.

                  I found the service manual, which was critical to know where to probe.
                  https://www.manualslib.com/manual/20...1e-Series.html

                  With it I was able to determine that my DKA board was bad, when P_ON#1/2 gets enabled REG_12 on the DKA board collapses. I'm assuming one of the downstream regulators has a short, but I couldn't work out which rail/component and replaced the DKA board entirely.

                  Unfortunately the 5-blinks...
                  06-28-2023, 11:52 AM
                • Nicktronic
                  Sony XBR-65X850D 2 Red Blinks
                  by Nicktronic
                  Hi all,

                  I have the subject TV and it will work normally sometimes but suddenly go black and give the 2 red blinks blink code. When this happens, I check the power supply board voltages and all I have is the Standby 3.3V and BL_ERR 2.2V. When it's working normally, all power supply board voltages look normal and stable. I've checked the backlights with a tester and they all test good. I've also read that the 2 red blinks is a faulty power supply board, so could it be throwing up an erroneous BL_ERR?

                  Any Sony experts out there that can help??...
                  11-19-2023, 06:51 AM
                • dumbdd
                  Sony 75X9400E TV.. 5 Red blinks
                  by dumbdd
                  I was using this TV for 5 years before it stopped working. I like this TV and would love to fix it myself.*

                  When I press the power button, the white led comes on (sony calls the module smart core) and then it switches over to 5 red blinks. No screen, no backlight, no relay click, nothing. I have disassembled the tv and found the service manual for 75x940e online. The manual suggests a faulty power board, TCON or the panel.**

                  The standby pin is at 3.3V. Fuses on the mainboard and TCON are fine. Caps on TCON also seem to be fine. When I turn on the tv the white led...
                  07-01-2023, 08:54 PM
                • x_orange90_x
                  Sony KD-60X690E 6 Blinks, no image
                  by x_orange90_x
                  I just got this today and it has the infamous 6 blink code. I've read it's quite possibly bad backlights, and I intend to check them soon. However, I was just curious if the Sony logo should it's shouldn't be appearing briefly between powering on and the light starts flashing. I've read at least one other person had the logo flash quickly, but mine does not show anything at all, not even a flicker. The green light comes on and after about 5 seconds the red light flashes. So I'd expect in this 5 seconds to see the logo. This leads me to believe it could be a power supply issue.

                  I...
                  12-10-2024, 09:10 PM
                • Loading...
                • No more items.
                Working...