My plasma tv (polaroid PLA5048) had a dark and hazy picture after hearing a loud pop. So far in trying to fix it, I have replaced 3 bad caps off of the main board (power board). I'm a little confused about the difference. Now I'm testing other components and when I test the SCK it reads .01. I'm not sure but I think this is for the thermistor, however when I look at them they all look good. Can anyone help me, I'm just trying to get my TV back.
-
-
Re: Polaroid plasma tv PLA5048 (bad picture)
post some good clear pictures of all the board in the plasma then we can advise you where to check next thanks. -
Re: Polaroid plasma tv PLA5048 (bad picture)
Here are some pics of the boards the 1st 2 are the power(main) boardAttached FilesLast edited by Imbackmk; 01-13-2014, 06:23 PM.Comment
-
-
Re: Polaroid plasma tv PLA5048 (bad picture)
Sorry having trouble loading pics here's the 2nd pic of the board I talking about.Attached FilesComment
-
-
Re: Polaroid plasma tv PLA5048 (bad picture)
Most likely ysus or zsus related..boards on each end of tv.Did I leave the soldering iron on?Comment
-
Re: Polaroid plasma tv PLA5048 (bad picture)
How can I test these boards? Also why where there bad caps on the main board if it's the Y or Z boards?Comment
Comment