Need schematic of Hisense LCD26V79 TVC

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Ahakim
    Member
    • Apr 2013
    • 64
    • USA
    #1

    Need schematic of Hisense LCD26V79 TVC

    I'm looking for the schematic of a 26" LCD TVC:
    Model: LCD2679V Hisense Technology
    100-240VAC 65W
    No HV from Inverter board (therefore no backlight). 5VS, 5VM, 12V all present from SMPS (which is by the way on same board with inverter). No 12V on primary of any of the 2 HV transformers. I find this normal since there is no direct contact between any of the pins of these 2 transformers primaries and the Vcc, i.e. the 12VDC. These pins are connected to The MOSFETs via 5 SMD caps in parallel. Is this a typical configuration?? There are 2 secondaries in each tranformer (supposed to deliver 1300V/7mA to CCFLs, as indicated on board i.e.4 lamps). I'd be grateful If someone could show me a similar inverter cicuit for any LCD TV, just to understand how this type of cicuitry works.
    Question: Do all inverter cicuit boards necessarily HAVE a fuse somewhere, in which case I have to loooooooooooooooooooook for it, & must find it? In fact I couldn't find any SMD fuse on this board.
    ANY HELP!
    Last edited by Ahakim; 06-14-2013, 04:42 PM.
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • x_orange90_x
      Vizio E55-E1 bad backlights or bad inverter?
      by x_orange90_x
      I just got this tv today and it appeared to have no backlight on. After taking off the rear cover and checking again in the dark I can see that MAYBE one quadrant is lit.. But still it's quite dim. I was going to check the LEDs with my tester, and I found LED 1 and LED 2 + pins on the wire from the inverter, but I couldn't identify a ground. Nonetheless I tried using a mounting screw on the inverter board and also the chassis as ground but regardless my tester reads 300 which is what it reads when there is no voltage draw.

      I don't know how exactly to test the inverter itself. Is it...
      01-29-2025, 09:24 PM
    • Coolgoodman
      Faulty Hisense 85Q6NAU TV
      by Coolgoodman
      85” Hisense TV

      Greetings,

      Request for Technical Assessment – Faulty Hisense 85Q6NAU TV

      Dear TV technicians of forum, I hope this message finds you well.

      I am writing to seek assistance regarding my 85-inch Hisense Smart TV, model 85Q6NAU, which is currently experiencing a fault. The unit is approximately two years old, and I am not sure if it has a warranty.

      I have attached a photo showing the issue for your reference. I would appreciate it if your experienced technician could kindly review the image and provide some insight...
      07-24-2025, 03:02 AM
    • Gentian
      APSINT3636VR 3600W APS INT Series 36V DC 230V AC Inverter/Charger schematic
      by Gentian
      I have a tripp-lite aspint 3636vr inverter charger which blow some of mosfet transistors. I replaced them repaired also the driver circuit and tested but the mosfets burn again.

      It work very well as inverter and also as charger if I let the rear switch in auto mode (inverter) and charger only(charging) but in auto when I connect the feed line 220V AC first time it pass ok to line and start charging the batteries but when I remove the feed line it pass to inverter mode and if I do it again the second time when passing from charging to inverter the Main transformer start making a...
      03-06-2023, 07:07 AM
    • ShahZaib Ghumman
      Can I Swap Screens Between Two Hisense 75” QLED TVs?
      by ShahZaib Ghumman
      Hey folks,

      I'm not a professional, but I do have a decent amount of knowledge when it comes to electronic repairs.

      A friend of mine recently bought a brand new Hisense 75” 4K QLED Smart TV (75E7NQTUK) but unfortunately, he cracked the screen just a few days later. Luckily, he had insurance and got a replacement right away but weirdly enough, the insurance company never asked for the broken unit back.

      So, I took it off his hands and figured I'd try to repair it myself rather than see it go to waste. I've been searching for a replacement screen but can't...
      1 Photo
      03-25-2025, 10:59 PM
    • valvashon
      Insignia NS-LCD19-09 (PS OK, Inverter problem?)
      by valvashon
      For some reason I'm just not going to let this 19" TV defeat me. I guess because I have a schematic to work from I feel like I'm oh so close.

      History- while adding a turn-on circuit I let a small screw roll under the power board. Worked through all of that circuitry, probably replacing a MOSFET and PWM controller that were not bad but I was following the service manual. Finally figured out that the power supply is in working order when the inverter section (for the backlights) is disconnected. When the +12 supply to the inverter is disconnected the +12 and +5 will come up...
      1 Photo
      01-04-2024, 01:44 PM
    • Loading...
    • No more items.
    Working...