UPS battery diagnosis

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • minitt
    Member
    • Jan 2009
    • 24

    #1

    UPS battery diagnosis

    hi,

    i have a 800VA UPS with data cable to monitor AC fail status and shutdown

    after designated time is passed but it dosent show battery charge level.(Not apc i guess)

    However it says it can output 480 watt on its back . its 220v 50HZ UNIT.

    24V system. 2x12V (7 amp each) so 24V @7 amp.

    Here comse the mystry part.

    i have a digital meter hooked up with the battry ternimal.

    **when connected to AC outlet the reading is 27V...

    so is it ok that the chrging Volt is 27 for 24v system?????

    ***then when the AC goes out UPS holds the PC but if AC blinks 4-5 times

    (such as during storm and heavy raining) my PC resets itself.

    but when it DID reset the battery voltage remained at 23-24.5....at dat

    voltage the pc should not reset ...am i right???

    battery is 1.3 years old.

    Should i simply change the battery or scrap the whole thing???

    How can i be sure bout the UPS unit without changing the battery????

    thnx

Related Topics

Collapse

  • Bowline
    Dell E6400 PT434 type Battery Charging Stuck at 1%. Battery Pinouts?
    by Bowline
    My question pertains to understanding the control circuity inside a Dell PT434 type battery used in Dell E6400, E6410 and other Dell notebooks?

    Does anyone have a circuit diagram for the inside of a Dell PT434 battery and/or a description of how the control lines work to control this battery?

    My reason for asking is I have a battery which I cannot get to charge beyond 1% in a Dell E6410 or E6400.
    The LED bar graph charge indicator on the battery shows one LED lighted when the info button is pressed.
    I have tried multiple different Dell power adapters. My Dell...
    06-11-2025, 10:13 AM
  • mkdj
    ASUS X571 no power : battery issue?
    by mkdj
    Hello everyone,

    Mark and model: ASUS X571
    Symptoms: not turning on. There is only the LED battery indicator working. The owner of the laptop told me this problem arrived one week after having changed the battery. He then managed to power on the laptop only once, and then it never powered on again.

    Tests already made:
    - Battery is charging when laptop is plugged in. The LED battery indicator turns white after a couple of hours of charge, indicating that battery is fully charged. However, laptop won't turn on anyway, with or without AC plug.
    - I have removed...
    07-14-2025, 09:16 AM
  • techfreak9356
    Vostro 3400 (LA-K033P) won't charge battery, everything else ok
    by techfreak9356
    I bought a Vostro 3400 motherboard (LA-K033P) to upgrade over my damaged Inspiron 5593 (LA-J091P) board. Everything else is ok except for the battery. This battery I am using now is already a replacement one since I disposed of the bloated original one. Back in the Inspiron 5593 motherboard, the battery charges fine and is identified just fine. However, with the upgraded motherboard, suddenly the replacement battery is labeled as "Not a dell battery". When I borrow a similar battery from my colleague (which did not have replacements yet), it is identified and charges just fine.
    ...
    09-14-2023, 11:10 PM
  • Document Archive
    ISL88739AHRZ ISL88739 Laptop Battery Charger Datasheet
    by Document Archive
    The ISL88739 & ISL88739AHRZ are a highly versatile combo battery charger
    configurable for operating as either a Hybrid Power Boost (HPB)
    charger or a Narrow VDC (NVDC) charger, supporting 2-, 3-, or
    4-cell batteries. Both configurations allow the battery to work with
    the adapter together to supply the system load when it exceeds
    the adapter capability, referred to as system Turbo mode. HPB
    charger configuration reverse-boosts battery energy to the system
    bus to help the adapter provide the system power in Turbo mode.
    NVDC charger configuration...
    11-05-2024, 03:28 PM
  • ferah831208
    Strange battery present behaviour in Lenovo Legion 5-15ARH05 mb model nm-d041
    by ferah831208
    Hello guys, i need help with this problem, I have a NM-D041 mobo, it came with low impedance in 3v linear regulator rail, the cause was a damaged EC controller ITE8227e-192. I ordered a new one and replaced it. This laptop have a different chip for keyboard management and it8227e pins for programming ITE chips are not accesible through keyboard interface, I flashed it using i2c interface pins with vertyanov programmer because laptop was dead and SPI flash didn't have power (only 3v EC) so it couldn't access firmware stored in SPI memory. I read SPI and extracted it8227 firmware from original BIOS...
    03-18-2025, 01:18 AM
  • Loading...
  • No more items.
Working...