Corsair CX-600 photos

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • frogz81
    Member
    • Oct 2012
    • 31
    • Indonesia

    #41
    Re: Corsair CX-600 photos

    Hi stj,
    you're right, the unit can revive after change main cap. I'm salvage from other PSU
    original cap is 270uF/400v change to 420uf/400v.

    without load all voltage seem OK,
    but
    when i connect lamp 12v/35 watt as load to molex (12V) the voltage is drop to 11.6 - 11,7.
    or when conect lamp to 5v, the voltage is drop to 4.6 v

    Any suggestion is there more section/part to check or damaged part caused from this issue.
    Or is it valid when connect load only to 12V or 5V (not simultaneously)


    Thank for your help.

    Comment

    Related Topics

    Collapse

    • bimole
      Weird behavior on 3.3V rail of a CORSAIR CX600
      by bimole
      Hi,

      A colleague gave me an apparently ill CORSAIR CX600.
      He told me that he heard a banging noise, and smelt the magic smoke.
      After tearing down the PSU, no burnt component, everything seems OK, but the PSU often refuses to stay ON. When shorting PS_ON to GND, the fan spins a bit a finally stops. No output voltages.

      I tried to treat some apparently bad solder joins and finally it seems to work OK... on the 12V and 5V rails!
      It's another story on the 3.3V rail...

      I have some devices to test deeply PSUs (scope, AC source, electronic load)...
      02-13-2025, 04:49 AM
    • Ibod
      Corsair cx600 psu & ASRock B450Pro4 mobo wont start
      by Ibod
      HI I have a PC using a Corsair cx600 psu & ASRock B450 Pro4 mother board that won't power on after a shutdown (replaced a dead drive in a raid array) Not the boot drive.

      With most things unplugged, including the 24 pin ATX connector, but not the ATX12v to cpu, I have +5.01V on the +5vsb pin 9 from the PSU. When I plug the 24 pin back in to the mobo, the +5vsb fluctuates between 1.1v & 1.9v.

      Not sure where to go from here ?

      Is the PSU at fault or is the mobo causing the problem

      Look forward to any help :-)

      If I plug the 24...
      02-08-2023, 11:00 AM
    • h0m3w0rk
      Random Shutdowns/Startup Failure with Corsair SFX 450
      by h0m3w0rk
      Hello everyone,




      I'm encountering a frustrating issue with my Corsair SFX 450 power supply. After an undefined period of operation, my PC will either suddenly restart or, in some cases, it won't start at all until I disconnect the power cable and reconnect it. This erratic behavior occurs intermittently, making it difficult to pinpoint the exact conditions under which it happens.




      For context, I have tested the PSU using an electronic load at 150W, and under those controlled conditions, it functions flawlessly. This leads me to...
      02-09-2025, 03:19 AM
    • saimom
      Asus FX507ZC4 DANJLFMBAB0 REV B I need photos
      by saimom
      Hello everyone!

      Please help me determine which microcontroller was in this place.
      Logically, I guess that this is a ddr4 PWM memory controller and some kind of Richtek, but which one?
      Thise motherboard came after another service, where they say that water got on the controller and it burned down and they dismantled it.
      They did not take photos before the intervention

      The DANJLFMBAB0 REV B board, schematics, boards and photos of the motherboard were not found on the network, but I may have searched badly-((
      Maybe someone has a photo of this piece,...
      12-17-2024, 08:51 AM
    • Davi.p
      Reduce the size of photos please..
      by Davi.p
      Hi all, i'm asking all to reduce photos to a more comfortable resolution before post, the better like around 2000x2000, otherwise many PC / Tablets / phones refuses often to load them or has strong defection... today's digital cameras integrated in phones especially are a mockery because them saves photos at enormous resolutions with much less the real definition, so reducing them is only a good deal.. THANKS!!...
      05-16-2024, 12:53 AM
    • Loading...
    • No more items.
    Working...