hi all..greetings
I have problem in last a week ..
my recent psu doesnt start normaly in 24pin 8pin motherboard
when plugged into the 24pin 8ppin motherboard .. .. psu does not turn on, but standby light is on ... if i push the power button theres no reaction ,still in standby condition..
but if i plugs into the 20pin and 4pin motherboard .. the psu run normal ..all the voltages (+12v, +5v , +5vsb.etc) within the limits of 5% tolerance ..
btw..this is not apfc psu ..still have switch for changing 100 /220 (passive pfc, of course) ..
i live in indonesia ..so i use 220v ( i already checked the apfc switch)
any suggestions and solutions?
done for inspecting :
1. the caps full of capxon
2. the secondary caps seem bulged ( just few of them)
3. powering psu with jumpering ps-on and ground ( green+black ) and 2 dvd rom for load..psu turn on normally ..voltage still within limit of 5% tolerance (checked with DMM)
thanks for help ..
ps:sorry for my bad english ..
I have problem in last a week ..
my recent psu doesnt start normaly in 24pin 8pin motherboard
when plugged into the 24pin 8ppin motherboard .. .. psu does not turn on, but standby light is on ... if i push the power button theres no reaction ,still in standby condition..
but if i plugs into the 20pin and 4pin motherboard .. the psu run normal ..all the voltages (+12v, +5v , +5vsb.etc) within the limits of 5% tolerance ..
btw..this is not apfc psu ..still have switch for changing 100 /220 (passive pfc, of course) ..
i live in indonesia ..so i use 220v ( i already checked the apfc switch)
any suggestions and solutions?
done for inspecting :
1. the caps full of capxon
2. the secondary caps seem bulged ( just few of them)
3. powering psu with jumpering ps-on and ground ( green+black ) and 2 dvd rom for load..psu turn on normally ..voltage still within limit of 5% tolerance (checked with DMM)
thanks for help ..
ps:sorry for my bad english ..

Comment