Hello, I have a legion pro 5 16arx8 serial number pf4bf4aw mb code nm-f251 rev1.0 which was dissasembled by the client for cleaning. Now it does start but for 20 secs after that fans run at maximum and then shut down. Found PU8302 burned but cannot identify it the part. It is written eHFAA on it but didn't found any info, no boardview, nothing. Can anyone help identify the part so I can order it from somwhere? Ataching some pictures of the motherboard, serial number and part. Than\k you
nm-f251 Schematic, boardview or help identify componente
Collapse
X
Related Topics
Collapse
-
by OnRepair1Hi i have been looking at a wheel from thrustmaster T300 there is a componente that its burn out and its impossible to read the code on in
The componente is the Q17 (Next to the fuse FB34) it seems that its starts with a 2 but nothing else i can see.
Does someone know or have the schematics of it?
... -
by pronesterHi guys,
I need some help to identify this burnt components of the GPU as per attachment.
FYI this is the GPU spec:
https://www.techpowerup.com/gpu-spec...cu-ii-oc.b2130
I have the boardview but it does not provide the parts number etc.
Does anyone have any info on this part of the circuit?
Many thanks.1 Photo-
Channel: BIOS & Schematic Requests!
-
-
by Much BugsThe Schematic and BoardView( *.cad ) of MSI Z390 A-PRO , the board model no is MS-7B98 Rev1.0-1.1 ....
-
Channel: Schematics and Boardviews
-
-
by rmfr1225Hello everybody,
I have the schematics already of this device but no boardview and it is being very difficult to locate the fault.
I have +3P3VAS but then nothing else, I suspect something related with 1V8 regulators, but without boardview it is very difficult to locate those components and or pads to test.
Does somebody has the boardview of this model? Or can point out where to test?
Thanks!-
Channel: Schematic Requests ONLY!
05-12-2025, 03:29 AM -
-
If anyone has the boardview and can share I would greatly appreciate it! I have the repair guide, but I still need the boardview. My BMC cannot initialize, likely due to damage around the enable switch....
-
Channel: BIOS & Schematic Requests!
-
- Loading...
- No more items.
Comment