I just received my new io programmer and it works great. I'm trying to figure out how to program the kb9542 with it. the kb9542 ENE files are 160kb compared to the usual ENE files that are 128kb. how to program the thing to read 160kb instead of 128kb?
-
Hi
somebody could explain me how to program ITE8987E with Vertyanov?
MB: DAG3DBMB8D0 REv. D
I can detect the EC but it not show the model, next I can read and try to erase but blank check is false.
neither I can to write, it is false, below I add the log:
ITE mode selected
check pins ok
selected motherboard DAG34AMB6D0 RV
15-AU IT8987E SHAN
CHECK GND
Now plug power to the motherboard
Device ID: EEEE
Device Revision: EE
ITE series detected
Flash ID: EEEEEE
... -
does anyone know how to program the ene kb9542? i understand that the dump is 160 kb. my rt806f detects the IC as a kb9010 -
Greetings and salutations!
I have a device that uses an N32G455RE. Unfortunately, its flash got corrupted. I have a dump of a working chip.
How can I program a specific region of the flash or the whole flash without touching the RAM, option registers, etc.?
I do not have a J-Link debugger and won't buy one, as I am not rich.
I have flashed a Nucleo board with an ST-Link to a J-Link just to find out that the ST-J-Link only supports ST chips.
What would be the cheapest and easiest option to program the Nations chip's flash without touching registers etc.?... -
ECFinder program for searching for firmware of multicontrollers and a number of BIOSes inside any binary files: dumps or unpacked update files.
Just Drag your dump in and choose capacity
Mod edit: link https://comsystem-tlt.ru/forum/viewtopic.php?t=759 -
I have a1706 820-00923-a, the smc in this board is bad (980 yfe tm4ea231) I have a new smc but the problem is how to program this smc, does anyone know about it pls help
Comment