how to program it8987E with Vertyanov? is not working

[ruletero]

Hi

somebody could explain me how to program ITE8987E with Vertyanov?

MB: DAG3DBMB8D0 REv. D

I can detect the EC but it not show the model, next I can read and try to erase but blank check is false.

neither I can to write, it is false, below I add the log:

ITE mode selected
check pins ok
selected motherboard DAG34AMB6D0 RV 15-AU IT8987E SHAN
CHECK GND
Now plug power to the motherboard
Device ID: EEEE
Device Revision: EE
ITE series detected
Flash ID: EEEEEE
Start erase in: 12/06/2023 09:21:24 p. m.
End erase in: 12/06/2023 09:21:33 p. m.
Erase OK
Start blank check: 12/06/2023 09:21:34 p. m.
error
0
0
Blank Check false
File size : 131072 byte
File size : 131072
Flash size :131072
Start writing: 12/06/2023 09:21:44 p. m.
Write false


Please your help, I don't have idea what is wrong.

Thanks

[mcplslg123]

Re: how to program it8987E with Vertyanov? is not working

This a very common error while programming EC chip. very likely the target EC chip is bad and/or not soldered properly.

[ruletero]

Re: how to program it8987E with Vertyanov? is not working

This a very common error while programming EC chip. very likely the target EC chip is bad and/or not soldered properly.

EC is the original, then, I'm going to replace it.

very thank you