-
hello guys i have a lenovo 520-14IKB CIUYA YB SA SD LA-E541P Rev 1.0 , it has a nuvoton ncpce388nb i know is programable, i been trying to program these nuvuton but it giving me problems i attach the svod i been using, can someone tell me the right way to program these kbc, with pins out please, all are ok i even have continuity from motherboard to svod, so i dont know what could be the problem.... -
-
Hi,
I have a problem with a Lenovo L14 gen 2 (intel) with Nuvoton npce68b.
I connected my svod4 with a 32pin cable to the keyboard connector. Ground is also connected and power for the mainboard. I can read the Nuvoton ID, but the dump is always empty. Does anyone have an idea? -
Hello, is svod 4 able to read emmc? Do I need a special board or is it enough to solder into the pinout and insert the other side of the cables into the programmer? somehow especially set the svod? -
Hi guys, I have an ASUS P8H61-MX USB3 motherboard that can't turn off the power supply because the PSON signal generated by the SIO chip always goes back to and stay at low state (below 5V) half a second after it went to high state (5VSB)
Also worth mentioning that the PSON signal will randomly switch to low state and therefore turning on the power supply and the computer as if a ghost has pressed the power button 🤣
The SIO chip is Nuvoton NCT5535D. Can't find a datasheet for it, only for NCT5532D (more or less the same though, just different pinout)
...
Working...
😀
😂
🥰
😘
🤢
😎
😞
😡
👍
👎
☕
Comment