Hey guys working on a water damaged A1990 820-01041 and have it going now but the left usb-c ports will not mount or see a usb device unless you reboot/restart or cold boot with a drive in and it will work but eject it and replug and it will not show up.
Any ideas where to start looking ?
R3461 did look like crap so it was replaced Q3460 looked ok so i left it but not sure what the correct readings would be here nor if its related to my issue.
Rain was sucked into it by the fans and it hit everywhere,the 2.5v&0.9v sdd rails were the worst hit and after the clean up it needed to be dfu restored for some reason
its also very slow to come back from sleep after closing the lid regardless of how long it was left ie 2sec's or 2 hours it always takes 1 minute to come up but the usb issue is the biggest
Any ideas where to start looking ?
R3461 did look like crap so it was replaced Q3460 looked ok so i left it but not sure what the correct readings would be here nor if its related to my issue.
Rain was sucked into it by the fans and it hit everywhere,the 2.5v&0.9v sdd rails were the worst hit and after the clean up it needed to be dfu restored for some reason
its also very slow to come back from sleep after closing the lid regardless of how long it was left ie 2sec's or 2 hours it always takes 1 minute to come up but the usb issue is the biggest
Comment