Working on a Lenovo W541 motherboard LKM-1 WS MB 12291-2 ... The issue was a water spill/liquid damage to the board. The damage was limited to the bios region. Originally there was no power to the board, there was damage to pin 7 & 8 on the bios chip in the photo, the pins had corrosion as well. Removed the bios and was actually able to make a copy of the bios (not sure if its a good copy).. I than flashed a new bios chip and cleaned the area that was affected, replaced the new bios chip and now I have power to the board. The only issue is now it turns on the fan spins then slows down and spins again, over and over this happens... The power button board lights up and stays on, however
every time the fan restarts the light dims and like its resetting.. Also the power button plays no part in starting or stopping the laptop, once powered the laptop starts automatically, as if there's a short. My question, where would a short on pin 7 & 8 come in at?
Voltages on the bios chip are as follows when powered on
pin 1 = 3 vdc than goes to zero and shoots back to 3 v
pin 2 = 1.5v than goes to zero and starts over at 1.5
pin 3 = 1.5v than goes to zero and starts over at 1.5
pin 4 = 0v
pin 5 = 1.2v than down to zero and back to 1.2v
pin 6 = 1.3v than down to zero and back to 1.2v
pin 7 = .5v than down to zero and starts over
pin 8 = .5v than down to zero and starts over
behaves like a short causing it to restart over and over? Any advice? could not find a schematic...
every time the fan restarts the light dims and like its resetting.. Also the power button plays no part in starting or stopping the laptop, once powered the laptop starts automatically, as if there's a short. My question, where would a short on pin 7 & 8 come in at?
Voltages on the bios chip are as follows when powered on
pin 1 = 3 vdc than goes to zero and shoots back to 3 v
pin 2 = 1.5v than goes to zero and starts over at 1.5
pin 3 = 1.5v than goes to zero and starts over at 1.5
pin 4 = 0v
pin 5 = 1.2v than down to zero and back to 1.2v
pin 6 = 1.3v than down to zero and back to 1.2v
pin 7 = .5v than down to zero and starts over
pin 8 = .5v than down to zero and starts over
behaves like a short causing it to restart over and over? Any advice? could not find a schematic...
Comment