Hi, I have a C920 Webcam that's not showing a picture just digital distortions (picture attached) is this fixable or wrecked? it was free so no loss :-) Thanks
Attached Files
-
-
Re: Logitech C920 Webcam not showing picture
Have a look at the youtube it might help
https://www.youtube.com/watch?v=nESATVNA33o -
-
Re: Logitech C920 Webcam not showing picture
bumpComment
-
Re: Logitech C920 Webcam not showing picture
bumping upComment
-
Re: Logitech C920 Webcam not showing picture
try new cables .. then new drivers . or other way round for cheapness .Comment
-
Re: Logitech C920 Webcam not showing picture
Nope, the cord is fine, the camera itsself must be damaged some how?Comment
-
Re: Logitech C920 Webcam not showing picture
it is looking that way yesComment
-
Re: Logitech C920 Webcam not showing picture
head device... had similar in the past.. if cable is no problem, not fixableIm Back... sort of...
Comment
-
Re: Logitech C920 Webcam not showing picture
Take photo of the pcb both side in hd and upload them.Comment
-
Re: Logitech C920 Webcam not showing picture
Sorry, I've been busy and not going to worry about it for now :-)Comment
-
Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.
The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.
Original T-con:
Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.
First replacement T-con:
I thought it might be t-con and ordered new t-con from china(supposedly tested)... -
This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.
Problem
TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode... -
Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
This specification for the LENOVO ThinkCentre ThinkSmart Edition Tiny M920q for Logitech can be useful for upgrading or repairing a desktop PC that is not working. As a community we are working through our specifications to add valuable data like the ThinkCentre ThinkSmart Edition Tiny M920q for Logitech boardview and ThinkCentre ThinkSmart Edition Tiny M920q for Logitech schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on...09-12-2024, 01:58 PM
-
I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.
I ordered a supposedly ‘new' Tcon board this time, and...
Comment