Re: Dell Inspiron 7567 LA-D993P odd charger issue
Yes! It is charging & the percentage is going up! :-D
We did it! Thank you so much for your assistance. Another laptop saved. :-D
It currently at 42% now....
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Dell Inspiron 7567 LA-D993P odd charger issue
Thanks, PQ301 is replaced with the donor & PQ306 re-installed. All mosfet mesurements are in the Mega ohms. Good to test? :-)...Last edited by Johndill; 11-18-2022, 07:10 AM.
Leave a comment:
-
Re: Dell Inspiron 7567 LA-D993P odd charger issue
PQ301:
Source & drain - 0.4 ohm
Source & gate - 7.1K ohm
Gate & drain - 7.1K ohm
PQ302:
Source & drain - 220K ohm
Source & gate - 220K ohm
Gate & drain - 7.1K ohm
PQ306 (off the board):
Source & drain - O.L
Source & gate - O.L
Gate & drain - O.L
Leave a comment:
-
Re: Dell Inspiron 7567 LA-D993P odd charger issue
PQ301:
Source & drain - 0.4 ohm
Source & gate - 0.425K ohm
Gate & drain - 0.425K ohm
PQ302:
Source & drain - 11.5M ohm - 120K ohm with probes reversed.
Source & gate - 8.6M ohm - 120K ohm with probes reversed.
Gate & drain - 0.430K ohm
PQ306:
Source & drain - 0.4 ohm
Source & gate - 0.434K ohm
Gate & drain - 0.435K ohm
Leave a comment:
-
Dell Inspiron 7567 LA-D993P odd charger issue
Hi, I have a Dell Inspiron 7567 LA-D993P that I've just got running.
There was corrosion around PU1503 which shorted PC1518 & blew PL1504. (Reference pictures attached)
I've replaced PC1518 & PL1504 & the laptop is now running however I now have another issue.
Here are the tested scenarios:
1. With the laptop running on battery, I plug in the 150W charger & the charger shuts off (no LED, protection mode) but the laptop remains running on battery.
2. With the laptop off, plug in charger (LED says on) & the front charging...Last edited by Johndill; 11-16-2022, 11:09 PM.
-
Re: APC UPS cap replacement
I've powered the board on without it and there is a bizzing from some where else on the board and still getting "DC Bus Over Volt".
Leave a comment:
-
Re: APC UPS cap replacement
So it will run without it? :-)
Thanks for the uF and tolerence identification. :-)
I had a search but cannot find any of the same physical size so it may be proceeded by a smaller model perhaps?...
Leave a comment:
-
APC UPS cap replacement
Hi, I have an APC SMX2200RMHV2U UPS and I'm looking for a replacement for this cap in the picture, it has melted I believe after a storm from what a friend said happened to it, it powers on and has "DC BUS Over Volt" error.
I've inspected the rest of the board and this cap appears to be the only issue I have found. I have removed the cap ready for a new one.
I'm located in Australia.
Also, can the board be powered on safely without this cap?
legs are 1mm size and about 37mm apart, leght 40mm, width 26mm, hight 41mm (excluding...Last edited by Johndill; 05-10-2020, 11:21 PM.
-
Re: Requesting Alienware 17 R3 schematic LA-C912P
Thank you very much mate! :-D...
Leave a comment:
-
Requesting Alienware 17 R3 schematic LA-C912P
Requesting Alienware 17 R3 schematic LA-C912P.
It is also the same as the 15 R2.
Bios chip does not seem to power on when power button is pressed, only get a solid red power button after about 20 seconds. GPU and CPU not turning on but the chipset is.Last edited by Johndill; 04-03-2020, 01:39 AM.
-
Re: Laptop panel has green tint & purple lines.
Hi, thanks for your reply, as stated in the original post, "It has been tested on a known good system & found to be a fault with the panel & not the system or cable." :-) Could it be a cap on the panels control board?...Last edited by Johndill; 03-09-2020, 08:51 PM.
Leave a comment:
-
Laptop panel has green tint & purple lines.
Hi, I have a laptop panel model LP173WF4 which has suddenly got a green/blue like tint and purple lines, You can see in the picture with MS Paint that it is not a white screen and you can compare to the white in the monitor in the background. Is this fixable & if so, what can I do? Thanks :-)
It has been tested on a known good system & found to be a fault with the panel & not the system or cable....
-
Re: Alienware 17 R1/Ranger la-9331p short
I'll have to put this board aside untill I get an opportunity to use a BGA rework machine. :-)...
Leave a comment:
No activity results to display
Show More
Leave a comment: