Back light Flickering

nbanti

Senior Member

Join Date: Apr 2011

Posts: 57
#1

Back light Flickering

08-24-2015, 04:14 AM

Hi dear all,

I have samsung laptop. With power adapter, When i increase or decrease the Brightness it is working normally. But if i do it with battery power, Screen get flickering and some noise come from LCD. If i plug the adapter that time, Flickering and Noise stop and LCD Works fine. I have change the LCD. But problem is same.
Please tell me what to do.

Thanks all.
Tags: None
polytek

Badcaps Veteran

Join Date: Dec 2013

Posts: 496

Country: TUNISIA
#2

08-24-2015, 04:57 AM

Re: Back light Flickering

it's better to post the laptop model or the motherboard code, my advice is try to update the bios to the last version,try another battery, try another lcd cable
Comment
nbanti

Senior Member

Join Date: Apr 2011

Posts: 57
#3

08-24-2015, 10:26 PM

Re: Back light Flickering

Thank you for the reply.

Laptop Model is 300E. And it is a Core i3 Laptop.

Thank you.
Comment

Previous template Next

Lift Master Garage Door wall switch display / motion sensor controller display disappeared no back light

by sam_sam_sam

This happened last Saturday and today I finally had time this morning before I went to work to replace two non brand capacitors

I will let you be the judge weather or not these are bad or not according to the blue ESR meter that I am using

I am comparing them to a brand new one that I installed

The display came back on and the programming was not lost which I was surprised by I would have thought that when the display went blank that so did the memory as well

I going to let it run for several days before I remount back on the wall next to the...
- Channel: General Electronics Technical Discussion
09-05-2024, 06:48 PM
tcl u65x9006 back light on but no picture sounf ok after 40 50 secs

by PNI E.

hi guys, i need your help again...i have tcl u65x9006. while i was watching it become darker like when a movie ends, little by little the image disappear. now if i turn on i have back light on, after like 1 min i have also sound but no picuture. the back light is on i take off one at time the ldvs but nothing change always no picture. i tried to cover with a piece of paper the pin of ldvs i cover like 7 8 pins but nothing worked. the tv stay with no picture. there is a tcon board.i checked the voltage there on the fuse i have 11,8 volts. there is caps in shorts on the exit of the tcon i have...
- Channel: Troubleshooting TVs and Video Sources
02-20-2025, 08:36 AM
vostro comes up with back light but no picture

by koby058

Hi people!!
The owner said it showed bad picture once in a while (attached)
I see that there is back light but no picture.
I want to ask if it is possible to disable the NVIDIA GPU and use the intel one?

Also attached schematic and BDV

LINK to schematic & boardview - https://www.badcaps.net/forum/troubl...ll-vostro-5590...
- Channel: Troubleshooting Laptops, Tablets, and Mobile Devices
07-13-2025, 01:03 PM
A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair

by howardc64

Problem

This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
- Channel: Troubleshooting Computer Displays
08-04-2024, 10:36 PM
Denon AVR 1908, High pitch noise on Surround back Left channel after long overhaul

by karatzdi

Hello,

I know some might say... just buy another one. Sell it as parts..!

So had this AMP for quite some time. Recently I saw light smoke coming out of the AMP. Had my fire extinguisher close by. Just kidding. Turned immediately all devices off from mains.
Let things cool a bit, and opened up the amp device. I clearly saw on the main board which hosts the 5X amp (5.1), 3 10 ohms 1W resistors had their leads looking black, while the rest of the remaining 2 x 10 ohms were brownish as being installed from factory.

Spent some time downloading the Service...
- Channel: Troubleshooting Audio Equipment
06-11-2024, 08:38 AM
Loading...
No more items.

Back light Flickering

Back light Flickering

Comment

Comment

Related Topics