Hp hedwig 6050a2993001

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • minaedward
    Member
    • Feb 2021
    • 34
    • luxor
    #1

    Hp hedwig 6050a2993001

    Hi
    I got a hot ic on an HP laptop board number hedwig 6050a2993001
    I didn't find the schematic of the board
    The ic is written on it L8=6C I believe it's a voltage regulator
    Anyone knows the part number for the ic?
    Attached image of it
    Attached Files
    Tags: None
    • mon2
      Badcaps Legend
      • Dec 2019
      • 14662
      • Canada
      #2
      Hello and welcome. If the markings have ‘=‘ then the manufacturer is Richtek. Up above is a thread devoted to parts and their markings.

      So your part can be found by searching out

      ‘L8= Richtek’ keywords or similar.

      https://www.richtek.com/assets/produ...S6256BC-03.pdf

        Comment

        • minaedward
          Member
          • Feb 2021
          • 34
          • luxor
          #3
          Originally posted by mon2
          Hello and welcome. If the markings have ‘=‘ then the manufacturer is Richtek. Up above is a thread devoted to parts and their markings.

          So your part can be found by searching out

          ‘L8= Richtek’ keywords or similar.

          https://www.richtek.com/assets/produ...S6256BC-03.pdf
          Thanks for your fast reply ☺️ 😍
          Very helpful information I Will look into it

            Comment

            Previous template Next

            Related Topics

            Collapse
            • disorder
              HP 2311 display, 3.3v regulator fried, need help to replace
              by disorder
              hello,

              i have a hp display 2311 to repair, totaly dead
              on the board, il have 2 capacitor 470µf that are dead and the 3.3v regulator : ax6630-33
              i have no such regulator, can i replace this one with a mic5209-33 (3.3v outpout regulator too) ?

              thank you
              07-27-2025, 04:34 AM
            • bilux
              uP0109: 2A Ultra Low Dropout Linear Regulator equivalent substitute
              by bilux
              Hello everyone,
              I want to find a replacement for uP0109 8pins, and i found this parts:

              uP0109 is "2A Ultra Low Dropout Linear Regulator"
              RT9199 is "Cost-Effective, 2A Peak Sink/Source Bus Termination Regulator"
              FP6137C is "2A BUS TERMINATION REGULATOR"

              can replace uP0109​ by RT9199 or FP6137C ?
              11-01-2024, 12:00 PM
            • playit
              diy - voltage injection possiblity with voltage and ampere regulator - possiblity ?
              by playit
              hello ,for diy voltage injector for short killer/finder -- is it possible to use something like this - LM317 DC Linear Regulator, DC-DC 4.5~40V Turn 1.2~37V, Step Down Power Module, Adjustable

              and ampere controller along (to make it zero amps ) with some addons(transistors diodes etc.) for it -- and use some 5v adaptor or 3.3v volt rail of my smps power supply as input and finally get 1v and zero amps for injecting voltage to find out short circuit component ? ..
              for source input -- can we use 3.3 -4 volt 18550 battery ?( i have some of those ) and then adding ampere regulator...
              02-26-2025, 05:39 AM
            • joliver82
              PS5 pro 1 beep and no boot
              by joliver82
              Hi guys,

              I have a PS5 pro board model VSM-010 which doesn't boot, when trying to start the console, it beeps once and the blue light is shown for one or two seconds and shuts down.

              I've been checking it, the UART showed the following errors:
              • 00 27/09/2025 1:25:53 80810001 Severe PowerSequence - Power Sequence Error - General Power Failure (Peripheral, GDDR6, APU, Data Line Short)
                |-(OK 00000000 80810001 FFFFFFFF FFFF0023 10000100 206E 0024 FFFF FFFF:2E)
                Click for TSB Information
              • 01 27/09/2025 1:25:53 C0810303 Low HDMI IC Problem or Data Line Short or
              ...
              09-28-2025, 06:22 PM
            • Document Archive
              ISL95831HRTZ ISL95831HRTZ-T ISL95831IRTZ ISL95831IRTZ-T Voltage Regulator Datasheet
              by Document Archive
              3+1 Voltage Regulator for IMVP-7/VR12 CPUs

              Compliant with IMVP-7/VR12, the ISL95831 provides a complete solution for microprocessor and graphic processor
              core power supply. It provides two Voltage Regulators (VRs) with three integrated gate drivers. The first VR can be
              configured as 3-, 2- or 1-phase VR while the second output is 1- phase VR, providing maximum flexibility. The two VRs share the
              serial control bus to communicate with the CPU and achieve lower cost and smaller board area compared with the two chip approach.
              Based on Intersil's Robust Ripple Regulator...
              11-05-2024, 03:24 PM
            • Loading...
            • No more items.
            Working...