Soldering an universal inverter lcd for laptop

[orientalsniper]

From: http://www.ebay.com/itm/251078921946...84.m1497.l2649

According to this page (http://www.lcdparts.net/howto/U_PIN.aspx) I should be looking for a 12v connection. But from original inverter cable connection I measure only 5.1v and 3.3v.

[jetadm123]

Re: Soldering an universal inverter lcd for laptop

On the original inverter look up the datasheet for the ccfl controller and find out what the minimum voltage is required for it's operation. If it's greater than 5 volts, then you have something wrong with the input voltage.

[orientalsniper]

Re: Soldering an universal inverter lcd for laptop

It's a 6pin inverter (TBD481NR), I couldn't find its datasheet, I think this is the closest http://pdf1.alldatasheet.com/datashe...X1692AIPW.html (9v-22v?)

[spidey]

Re: Soldering an universal inverter lcd for laptop

check it from mobo schematic.

[orientalsniper]

Re: Soldering an universal inverter lcd for laptop

wow, I'm dumb, found it (it's 5v), thank you.

[int0x13]

Re: Soldering an universal inverter lcd for laptop

how did you solder the universal inverter board to your motherboard connector?

[selldoor]

Re: Soldering an universal inverter lcd for laptop

This thread is 2 years old and probably different make of laptop????