Help Identifying this component

[rop12770]

Hi

I have this Fujitsu Siemens v3515 with a LM10W MB.
It has a burned component (L13) near the jack.

But it doesn't have any ID.
Can someone tell what it is?

My camera only left me to take 1 photo (run out of batteries hehehehe).

I hope with only this picture someone can help.

Thanks

[mariushm]

Re: Help Identifying this component

L is reserved for inductors so that's an inductor. It should say on it the value. put some batteries in the camera and point a flashlight at it and get better pictures.

[rop12770]

Re: Help Identifying this component

Hi Mariushm

I have looked with my magnifying glass and I can't see nothing on it... Weird...

[mariushm]

Re: Help Identifying this component

Read what's on that rectangular chip near it and write it here.

That's the chip that regulates power or does something with that inductor - if you get the datasheet for it, you may find some typical circuits in it, and deduct the inductor size from those circuits.

[xaviero1412]

Re: Help Identifying this component

i suspect it as power-diode.... maybe, just a guess...

[mattbrad2]

Re: Help Identifying this component

According to the schematic its a choke. 33Ohm, 10A, 100Mhz.

[budm]

Re: Help Identifying this component

It does not tell you the Henry value? 33 Ohms with 10A rating is pretty high resistance for the inductor that can handle 10A. It also looks like Common mode choke filter for the power input circuits.