Lenovo nm-d471 fv1 fuse blown

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • NConstantinou
    Badcaps Veteran
    • May 2017
    • 348
    • Cyprus
    #1

    Lenovo nm-d471 fv1 fuse blown

    I found that fv1 on one side i have 19v and on the other side 0v.
    The fuse is 3a 32v FOR BACKLIGHT.
    I do not have such a tiny fuse.
    Can i replace it with a wire and what size.

    I know i am overpassing fuse but i don't have any other solution.

    Thanks
    Tags: None
    • mcplslg123
      Badcaps Legend
      • Jun 2015
      • 7262
      • india
      #2
      Re: Lenovo nm-d471 fv1 fuse blown

      Putting a jumper for fuse is not recommended but will work if there is no other problem. Newer lenovo boards fuse are very tiny-You can go for a smilar rating fuse although in bigger size and solder one pad of the new fuse to pcb one side and connect a jumper wire from other pad to fuse. That way you will still have the protection of fuse.

        Comment

        • NConstantinou
          Badcaps Veteran
          • May 2017
          • 348
          • Cyprus
          #3
          Re: Lenovo nm-d471 fv1 fuse blown

          Thanks mcplslg123,

          i will take your suggestion, it makes sense.
          thanks again

            Comment

            Previous template Next

            Related Topics

            Collapse
            • coasterghost
              Lenovo T14 Gen 2 Type 20XK Model 20XK0069US Odd Charging Issues
              by coasterghost
              For Badcaps Readers, Please note that I am hopefully going to present this same message to Lenovo to see if they have any insight to the matter as well and figured to share the entirety here for clarification. The System is out of warranty as it is but does have the option to have it extended.

              Model Information: T14 Gen 2 (Type 20XK, 20XL) Laptop (ThinkPad) - Type 20XK - Model 20XK0069US
              Board: T14 Gen 2 (Type 20XK, 20XL) - Type 20XK.

              System Hardware:
              Processor: AMD Ryzen 7 PRO 5850U
              Memory: 1x 16GB DDR4 3200 (Soldered on Board); 1x Crucial 32GB DDR4...
              09-08-2025, 10:46 PM
            • Babbar
              Argon SA1 audio amplifier power-supply - fuse blown after fixing the short?
              by Babbar
              I found a project in the electronics trash yesterday. A nice Argon SA1 audio amp with some electrical issue. Took it apart and saw that the 4A250V fuse was blown so started lifting components to find the short. Eventually got to two MOSFETs (model FTA14N50C) that are shorted and when i took them out the short was gone.

              Now i didn't have any replacements of the same model of course but i found a couple with pretty similar spec i thought (K10A60D & K12A50D) and put them in. Also replaced the blown fuse with a 3.5A250V one. Checked another time for short circuit and plugged it in....
              04-12-2024, 01:12 AM
            • drscoot
              HP X360 convertible battery blown fuse error, not charging
              by drscoot
              HP Modelnumber: 14-dh0061nb​
              This laptop had a shorted cap on a Vcore section. After replacement is works again. But there is still a battery issue.
              The battery is HT03XL and with the built-in component test from HP, in the Power section, I get an error: Logic State: Calibration required (20), Charge state: Blown Fuse (42)
              I have another same battery, also with error: Logic State: Very Weak (70), Charge state: Blown Fuse (42)
              And a third battery TF03XL (looks identical) with error: Logic State: OK (0), Charge state: Blown Fuse (42)
              All these 3 batteries are charging...
              charging section
              2 Photos
              12-15-2023, 05:54 AM
            • beetle1303
              Carver CM-1090 - Power relay clicking on & off, then fuse blown after 20-30 seconds of power cycling.
              by beetle1303
              I gotten a Carver CM-1090 amplifier from a friend who has kept it in storage for decades. Opened it up, thick layer of dust cumulated everywhere. Vacuumed it semi-cleaned, and blown off as much as possible the remaining dust. This is a 220V version.

              On initial powered up with nothing connected - it works with all the lights and button indicator lit up as pressed, etc. I then powered off, connected a CD player into the CD RCA input and powered it on. It seemed to work for a short while and when I turned the volume up and down to see the the VUs works, the power started to clicked off...
              3 Photos
              01-13-2025, 08:49 PM
            • Acnologia
              Lenovo Thinkpad E15 Gen 2 NM-D011 - No display ? External , yes!
              by Acnologia
              Here is a pretty crazy one.

              Step 1.
              Laptop was brought to me as dead not working. Removed everything , cleared everything.
              Step 2.
              Some liquid damage close to the Type - C connector, and the connector even though it was cleaned wasn't charging the battery . Removed the Type-C port, and replaced it. Now the laptop turns on and charges battery. Shows external screen , not internal.
              Step 3.
              Took out the screen and checked it to a secondary Gen 2 i have, screen works like a charm.
              Step 4.
              Lets ,dive into the board. I see the edp cable on the...
              05-07-2025, 07:16 AM
            • Loading...
            • No more items.
            Working...