Hello, I have a PS2 fat console that has no 12V on the power supply board.
Thinks that I checked:
I have 340V on the transformer's input but 0V on the outside (the DC side).
I have checked the optocoupler and I have 1.3V on the hot side and 0V on the DC side. I remove the octo from the board and it is ok
Board look's pretty simple but cannot figure it out
Thinks that I checked:
- Input
- Fuse
- 4 rectifier diode
- all small diodes on board
- replace the 2 green caps
I have 340V on the transformer's input but 0V on the outside (the DC side).
I have checked the optocoupler and I have 1.3V on the hot side and 0V on the DC side. I remove the octo from the board and it is ok
Board look's pretty simple but cannot figure it out
Comment