Ultrasonic Bath

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • barry wilkins
    Senior Member
    • Aug 2009
    • 172

    #1

    Ultrasonic Bath

    Circuit for an Ultrawave bath ,the recovery diiode was short circuit.
    Barry Wilkins
    Attached Files
  • stj
    Great Sage 齊天大聖
    • Dec 2009
    • 31002
    • Albion

    #2
    Re: Ultrasonic Bath

    check the film capacitors - i'm starting to see more and more of them dropping in value on mains circuits!

    Comment

    Related Topics

    Collapse

    • tmcw
      NEY Ultrasonic bath - magic smell
      by tmcw
      Does anyone know much about ultrasonic baths?

      I got one here at work, a NEY Ultrasonik 2QT/H, was in the trash, lovely smell of "magic smoke" having recently been emitted. Might have been the Engineering Dept that dumped it.

      Anyway, the sonic and heating lights on the front come on when plugged in and switched on, but no familiar noise I'd expect (like the sound effects from old Flash Gordon tv series of the 30's).

      Opened it up, and see some remains of something that was on the piezoelectric device on the underside of the bath, but not sure...
      04-19-2023, 05:14 AM
    • Astonished
      Fixing the Charge Circuit of the Batteries of the DC Motor
      by Astonished
      Hi friends of electronics

      What you see in the video and pictures attached is the circuit for charging the batteries of a DC motor.

      The problem is that this circuit cannot charge the batteries (3 1800mAH NiMH batteries) any more. When the circuit was OK, its green LEDs lit up one at a time to show that the batteries have charged more. But now that the circuit is flawed, LEDs light up as you see in the video and at the same time successive beeps are heard.

      Please help me fix this circuit.

      (the datasheet of the IC: https://pdf.datasheet.live/28...
      01-28-2025, 06:24 AM
    • rddube
      Lenovo L490 Ram voltage circuit malfunction
      by rddube
      Hello friends,

      Looking for some guidance here. The RAM voltage circuit on this motherboard keeps burning out PU301 which is a RT8231AGQW. Copy of the board with the burnt chip attached with some voltage measurements and copy of the schematics also included.

      I think I've checked almost every component in the circuit, but when I change the RT8231, the laptop starts I have 1.2V on the inductor for about 10 seconds and then the RT8231 goes south and no more voltage on the inductor. All other voltages on the laptop are good, this is the only one conking out for a reason I...
      07-15-2025, 04:41 PM
    • Tarot Superstars
      Short Circuit tester
      by Tarot Superstars
      Hello.
      I have seen a short circuit tester made with 3 * 9V batteries, a voltage limiter component and a resistor connected to the probes of a multimeter.
      The theory is that the meter becomes sensitive enough to read very low resistances and the lowest resistance to ground on a circuit is likely to be a short circuit in that area.

      Link
      The Amazing $1 Short Finder Upgraded! Convert ... - YouTube
      https://www.youtube.com/watch?v=0eixDdCpiO4

      My multimeter isn't normally sensitive to very small resistance, but when I put a 1 mega ohm resistor...
      09-25-2023, 09:11 AM
    • M1NEBLANK SHOW
      MSI B250 Gaming M3 Short circuit in CPU power supply circuit
      by M1NEBLANK SHOW
      Hello. MSI B250 Gaming M3 board, short-circuit on the power supply. Found a problematic mosfet VQ1
      (N-PK616BA_PDFN8-HF) soldered it out - short circuit is gone. I replaced VQ1 + VQ5 (N-PK632BA_PDFN8-HF). VQ1 was replaced with PK618. After starting attempt VQ1 is lit again. What can be the problem? In the driver?

      Schematic and Boardview here
      ...
      04-04-2025, 03:57 PM
    • Loading...
    • No more items.
    Working...