Ps5 edm-020 3sec BLOD

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Wompatti-
    New Member
    • Jul 2025
    • 1
    • Suomi
    #1

    Ps5 edm-020 3sec BLOD

    I have a ps5 with blue light flashing about three seconds when I press the power button and then it turns of. Second press, only beeb but nothing else. Third press, 3sec blod etc...
    BUT the weird part is if I unplug the power cord and put it back, the console will start without pressing the power button and give that 3sec blod.
    UART shows error code 80800024 and nothing else. There are no cracks on the apu. No shorts on the board that I can find. All standby rails are present and all power on rail will show up for that 3second period. I've tested with two different psu and reflashed the bios.

    Any idea what could cause the ps5 to turn on just by connecting the power cable?
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • Woodsworth
      PS3 CECHC03 60GB YLOD Troubleshooting
      by Woodsworth
      I have a post on psx-place for this but thought I'd try here as well in case anyone has experience or the schematics or any kind of help. Here's the original post from psx-place:
      START
      Hi, so I bought a YLOD Fat PS3 as I wanted a repair project and thought it would be a good way to get experience. I was able to solder to the RX, TX and Diag pads on the COK-002 motherboard and was able to get external access and retrieved the codes. I haven't powered it on beforehand so these should be the last ones. I did try to get internal access immediately after but kept getting scopen response...
      03-19-2024, 07:58 AM
    • smic717394
      iphone XS turns off when press on screen.
      by smic717394
      Hi,

      I have a iphone XS that came in for a screen replacement, the screen was badly cracked, and inside missing scues, on the back of the screen still the blue protector, the screen was a LCD. So we replaced the screen and all good, installed the screen and we noticed that pressing the screen with a bit of force but not excessive, the phone dies. After plugging the charger it turns back on, but again if you press it it dies. I open the phone again, and I can't see anything major, with the phone open, if I press on the logic board, battery, charging board, or even putting pressure on...
      07-25-2024, 10:16 AM
    • BMCappelletti
      Lenovo Thinkpad E14 Gen3 stuck on "To interrupt normal startup, press Enter" screen
      by BMCappelletti
      Hi everyone.
      Lenovo Thinkpad E14 Gen 3, stuck on the "To interrupt normal startup, press Enter" screen.
      Found a lot of people with this issue, but with no definitive answer. Some people managed to get away accessing BIOS, going to Startup and turning off "Option Key Display". For me that only removed the interrupt normal start up message, leaving only the Lenovo logo.
      Most people say hitting Enter does not work. It's true, if you wait a few seconds. But if you hit Enter right away you get the options to enter BIOS (which works), run diagnostics (goes to a...
      02-18-2025, 12:22 PM
    • Puuhis79
      Ps5 edm-40 blod
      by Puuhis79
      Ps5 came with only beeps nothing else, i hook up uart -> ram bank4 error (hynix chip) ordered same type, replaced chip with bga station, now gives fan spin and blod 1s
      and uart gives 80801F12 code… tried to look up the code but no succes. Atleast message for ram bank4 is gone
      2 Photos
      11-09-2024, 07:08 AM
    • eliemgh
      lenovo t14 i7 10 gen : I press the power button and there is a loud fan noise
      by eliemgh
      lenovo t14 i7 10 gen : I press the power button and there is a loud fan noise for about 3 seconds and power light is on. Nothing on display screen. i have removed the battery and bios battery still the same. i have put yesterday on update and charger ,i have leave and back and see this problem. Any One Can help Me ?
      09-27-2024, 02:40 AM
    • Loading...
    • No more items.
    Working...