well it doesnt have to be the same to function,
but ideally you want it to fit the board and poke through the case the same way.
otherwise you would have it hanging out on wires.
gotta say, finding exact match for slide switches can be hard - specially the side-angle type
if your skilled enough to desolder the old one you could clean and reassemble it with some grease inside .
but ideally you want it to fit the board and poke through the case the same way.
otherwise you would have it hanging out on wires.
gotta say, finding exact match for slide switches can be hard - specially the side-angle type
if your skilled enough to desolder the old one you could clean and reassemble it with some grease inside .
Comment