you may have answered your own question.
lets investigate the switch, how it connects and how it's mounted.
-
Spooky2 XM signal generator dead.
Hi,
Was working fine, but now dead, tried different power supply and still the same.
No noticeable marks on the circuit board.
The only possible issue I can think of, was that I wasn't using the switch on the unit to turn it on/off, I was using the wall socket (For a few months), because I thought the switch was getting a bit loose.
What info do you need to try and troubleshoot?
TIA
-
This specification for the Acer Switch Switch V 10 SW5-017P Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Switch V 10 SW5-017P boardview and Switch V 10 SW5-017P schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...09-06-2024, 05:30 AM
-
Hello, i bought dead nintendo switch oled.
after plugging charger with amp meter device shows 5v and 0,0 or 0,02 amperage draw.
I inspected motherboard and someone tried to reflow or replace m92t36 and didn't do it well, i resoldered it proper and find that usb-c fuse was blown too(replaced it).
After this device started to draw 15v and something around 0,48 but only for few seconds after this returned to 0A draw.
I tried to plug motherboard without battery - shows 15 0A and when charger was pluged i put battery back in then console started to charging battery but stuck... -
Laptop model: Sp513-54n-74V2
Testing power rails (separated by chip) reveals:
19V_DCBATOUT - (active)
5V_AUX_S5 - (active)
5V_S5 - (active)
3D3V_AUX_S5 - (active)
3D3V_S5 27Ω - (good) - enabled by Nuvoton chip
1D8V_VCCIN_AUX - (good) - enabled by 1D8V_S5 PG signal -- (dependent on 3D3V_S5)
1D8V_S5 41Ω - (good) - enabled by 3D3V_S5 PG signal
1D05V_VNN_BYPASS - (good) - enabled by 1D8V_VCCIN_AUX PG signal... -
Anyone got any Shelly remote devices around here?
I’ve got a few of these and they were all working fine for about a year. Today I noticed that one of them that controls a single light switch isn’t working at all. I mean it’s so dead, even the light switch doesn’t control the relay. No clicking, no anything whatsoever. Unfortunately it’s in the basement in a dark room and trying to get it out is going to be interesting. Maybe there is some carnage in there, who knows. It was hooked up to power mains.
The other exact same one is in the same room,... -
Hi everyone, over the past few months i have taken a deep dive into motherboard diagnostics and I love the challenge. Currently im trying to learn all about the signals that travel around the motherboard, such as frequencies, enable signals High and Low logic states etc. And i have been learning to read and using the Schematics for this board that i requested here on Badcaps forum, from a few months ago, this is such a great place for these.
I’ve been working on a GA-970A-DS3 (rev. 1.0) that does not post. This motherboard has been my main learning board. I would like share...11-23-2023, 11:02 PM
Leave a comment: