XBox 360 All Polymer Capacitors

[OriginalDaggers]

As the title says, Xbox 360 Polymer Capacitors, replacing all on a Kronos 1 revision board.

I went over a thread here (Xbox 360 with blown caps) and gather some extremely useful knowledge!

If I have things right, I can replace them TO

x9 : 1500uF 16V 10x20mm
TO: 470uF Nichicon FPCAP R7

x2 : 820uF 6.3V 8x12mm
TO: 2.5V 820uF Nichicon FPCAP R5

On this revision, there are other 820uF polymer capacitors for GPU/CPU - I'll be replacing those anyway with the above FPCAP R5

What's a good replacement for the smaller caps they are..

x12 : 100uF 16V

x7 : 220uF 10v

[stj]

you can get 100uf and 220uf polymers
going from 1500 to 470 is a mistake probably, why not fit 1500uf polymers?
they are really cheap on aliexpress or if you can get kemet brand from regular suppliers

[прямо]

1500uF 16V = 820uF 16V PCAP
820uF 6.3V = 470uF 6.3V PCAP

The polymer caps that are already onboard don't need to be replaced unless they have gone bad.

The smaller caps don't need to be replaced with polymers.

[OriginalDaggers]

you can get 100uf and 220uf polymers
going from 1500 to 470 is a mistake probably, why not fit 1500uf polymers?
they are really cheap on aliexpress or if you can get kemet brand from regular suppliers

the other thread stated, The Slim Models uses 470uF … I have yet to order any caps but digikey is my go to

[OriginalDaggers]

1500uF 16V = 820uF 16V PCAP
820uF 6.3V = 470uF 6.3V PCAP

The polymer caps that are already onboard don't need to be replaced unless they have gone bad.

The smaller caps don't need to be replaced with polymers.

Half the capacity? due to the faster discharge rate?