New FV24 motherboard

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Chris1992
    Badcaps Veteran
    • Apr 2005
    • 561

    #21
    Re: New FV24 motherboard

    Not so awesome if they replaced with crap though. Looks like nichicon so no probs.
    The great capacitor showdown!

    Comment

    • pinobot
      Member
      • Mar 2006
      • 14
      • Netherlands

      #22
      Re: New FV24 motherboard

      The guy said the caps are the same as on Intel mobo's.
      Did the 7volt thing with the processorfan, casefan and powerfan, it's al lot more silent now, especially the fan in the powersupply is a screamer, even at 7 volts it still is making too much noise.
      Probably buy a fanless powersupply like this one: http://www.mini-box.com/s.nl/sc.8/ca...it.A/id.417/.f and a C3 processor.

      Comment

      • Chris1992
        Badcaps Veteran
        • Apr 2005
        • 561

        #23
        Re: New FV24 motherboard

        Intel boards use nichicon, rubycon, so that's good news.

        EDIT: Dont bother getting a fanless PSU, just swap out the PSU fan for a lower-flow one. You can safdely run the fans at 5v too.
        The great capacitor showdown!

        Comment

        • tiresias
          Badcaps Veteran
          • Feb 2006
          • 489

          #24
          Re: New FV24 motherboard

          The newly installed caps do look like Nichicon, which would be immeasurably better than your old, bulging, Paul&Art caps. "That's IT" 's service also appears to be very good - probably worthy of it 5-star score on the tweakers.net pricewatch I linked to.

          About the fans, it may well be, as Chris said, adequate to run them on 5v - although you will have to make sure this is the case - some fans will not be able to start at this voltage, although they will continue spinning if they are already in motion.

          Comment

          • PeteS in CA
            Badcaps Legend
            • Aug 2005
            • 3579
            • USA, Unsure of Planet

            #25
            Re: New FV24 motherboard

            The three recognizeable Nichicons are PS series. Pretty good series, the RiHS-compliant version of the PR series. Not the newest or the lowest impedance, but a good performer.
            PeteS in CA

            Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
            ****************************
            To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
            ****************************

            Comment

            • Chris1992
              Badcaps Veteran
              • Apr 2005
              • 561

              #26
              Re: New FV24 motherboard

              All 12v DC fans I have, including one rated only down to 10v, start reliably at 5v.
              The great capacitor showdown!

              Comment

              Related Topics

              Collapse

              • glovecaps
                Asus ROG Strix Scar G533qm with a G733qm Motherboard, can I modify the Bios to accept G533 Bios
                by glovecaps
                Hello,

                I have a Asus ROG Strix Scar 15 (G533QM) that had a dead motherboard (Graphics card dead) and after trying to fix the motherboard with no success, I bit the bullet on a sale for a new motherboard. I ordered a motherboard for the 15 inch model which is the one that I have, and when the motherboard arrived it wasn't for a little while that I saw it was from the 17 inch model.

                My question is, can I update the Bios on this G733 motherboard to a G533 Bios.

                The reason for wanting to do this is that the keyboard isn't working as it should, and I think this...
                11-25-2024, 04:23 PM
              • barrymoats
                Issue with Shuttle SS56G Motherboard KTS24.5G1e
                by barrymoats
                Hello,
                I have a Shuttle XPC SS56G1 that I suspect has some faulty capacitors. Additionally, there's a missing component at location X5. This part is a small silver can, positioned horizontally, with the number KTS24.5G1e stamped on it. Before I replace the capacitors, I need to identify this part and find out where I can purchase one. Any assistance would be greatly appreciated.
                06-11-2025, 03:41 AM
              • keeper5511
                Shuttle AS45GT Motherboard problem
                by keeper5511
                Hello everyone. I have just aquire an old motherboard from a friend (Shuttle AS45GT). I 've tried to boot the modo with no result as aupply lights are flashing when there is power supply but i get no picture and beep sound. CPU is heating very slowly without a heatsink and i realise that reset switch is not working. When i used a PCi diagnostic card i get different messages every time like 08 or 0C or 0d and i noticed that RESET light remains steady on the card. When i measure reset pin with polimeter i got 0V on it. I also have 12v light NOT flashing on diagnostic card. Can anyone help me result...
                05-22-2024, 01:10 PM
              • Docus
                Legion Y540 17irh motherboard issue ( need help to know how to diagnose my motherboard)
                by Docus
                Hi everyone 😀,

                I'm here today to ask for help with repairing the motherboard of a Lenovo Legion Y540 17IRH.

                To give you some context, I'm passionate about computer repair so much so that I've invested in a lot of tools and started practicing on dead and old hardware. I've been learning how to solder and desolder components, mostly focusing on phone repairs.

                Recently, I bought a broken Lenovo Legion Y540 17IRH for just €150, and there are two main reasons why I made this purchase:
                1. I already own the exact same model, but its plastic chassis is badly damaged.
                ...
                06-10-2025, 04:24 PM
              • Archimedes
                HP Envy 17-3290NR 3D Blank Screen - motherboard Louis V1.1 6050A2489901
                by Archimedes
                Subject is a blank screen issue in HP Envy 17-3290NR 3D version laptop with motherboard Louis V1.1 6050A2489901 MB-A02. Production year is 2012. This one is a 2nd hand motherboard which I could use it for few months only. Suddenly no output from the internal display and also no signal from HDMI port then Windows out of order after few boots.

                Caps lock working normally and no HP's caps-lock warning blinks. Making a hard reset and replacing the RAM sticks or using different slots didn't help.

                Fans are spinning. Blindly could install windows11 and got the device manager...
                07-30-2024, 05:14 PM
              • Loading...
              • No more items.
              Working...