Announcement

Collapse
No announcement yet.

Abit KA7-100

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #21
    Re: Abit KA7-100

    Looks much better... thanks for the advice, topcat! Still waiting on the MOSFET to finish the board, though...

    Ludicrous gibs!

    Comment

      #22
      Re: Abit KA7-100

      With an ohm meter, every lead should be "open" or very very high resistance with respect to every other lead. The same should be true with a diode checker except if you connect the "+" lead to the Source and the "-" lead to the drain: that should read like a diode. This assumes an N-channel MOSFET; with a P-channel, the polarity of the diode checker leads would be reversed.
      PeteS in CA

      Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
      ****************************
      To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
      ****************************

      Comment

        #23
        Re: Abit KA7-100

        It lives!





        Works great, even with the busted up MOSFET situation... the jumper wire appears to be holding up . It's installing WinXP now, ready to start stress testing!
        Ludicrous gibs!

        Comment

          #24
          Re: Abit KA7-100

          Nice!

          Well done!
          <--- Badcaps.net Founder

          Badcaps.net Services:

          Motherboard Repair Services
          ----------------------------------------------
          Badcaps.net Forum Members Folding Team
          http://folding.stanford.edu/
          Team : 49813
          Join in!!
          Team Stats

          Comment

          Previous 1 2 template Next
          Working...