Can someone please provide with the code of this component surrounded in red.board is eax655431 01.
Attached Files
-
Hello Everyone,
I have an Onkyo TX-SR353 Audio/Video Receiver (5.1 ch with HDMI) that I am having a really hard time diagnosing and I'm about to throw this in the junk and go buy a new unit that is on sale until the 7th.
Symptoms:- Intermittent (part of the reason why i'm having a hard time isolating problem), sometimes will work for 10+h at a time without issue
- Original symptom was wife reported loud banging noise (like someone was banging on the wall with their fists) from the LEFT SURROUND speaker and then the unit shut off.
- I swapped the Left and Right surround
-
Hey guys, I have 4 of these switches.
One switch works as intended - Boots, Accepts configuration, Provides POE. However, after about 3 days the switch stops responding. Won't recognize console USB cable inserted, TX/RX lights stay lit when cables unplugged. Works again after power cycle.
The other three will boot, accept configuration, and will uplink to the network. However they won't provide power to connected POE devices. I've ruled out configuration issue, as I have cloned the configuration from the 'working' switch to all 3 of these non-working switches.... -
Hello, I noticed that was become almost impossible to desolder component with my hot air station. I measured with meter : air at output is at 220 degree celsius max, even set at 500 degree. So something is bad. Maybe temperature probe inside ?
Not yet disassembled, have you see some « well know » ou frequently issues to this sort of tools pls ? -
The ISL88739 & ISL88739AHRZ are a highly versatile combo battery charger
configurable for operating as either a Hybrid Power Boost (HPB)
charger or a Narrow VDC (NVDC) charger, supporting 2-, 3-, or
4-cell batteries. Both configurations allow the battery to work with
the adapter together to supply the system load when it exceeds
the adapter capability, referred to as system Turbo mode. HPB
charger configuration reverse-boosts battery energy to the system
bus to help the adapter provide the system power in Turbo mode.
NVDC charger configuration...11-05-2024, 03:28 PM -
Hello,
I recently installed a new SSB board (model from ASWO) in my Philips 65OLED818/12 FZ1 television after the original board failed due to a lightning strike. The TV now powers on and the Ambilight works, but there is no picture displayed.
I believe the panel ID is TPM23.1E, but I can provide the exact panel code if needed.
Could you provide the correct NVM.bin file for this model and panel? If there is another solution—such as firmware or service mode initialization—I would greatly appreciate your guidance.
Thank you in advance for...
Comment