KOORUI 24E4 monitor with HKC HKM238Fj01 panel I need help with identifying TCON ic.

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • SendyCatKiller
    New Member
    • Jul 2023
    • 3
    • Poland
    #1

    KOORUI 24E4 monitor with HKC HKM238Fj01 panel I need help with identifying TCON ic.

    Hello! I am looking for help with identifying this tcon chip on KOORUI 24E4 monitor.
    Driver board number: pn238ct01-3-xc-2
    Other IC on the driver board: NT71265MFG-001




    Attached Files
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • x_orange90_x
      TCL 50S535 bad tcon or panel issue?
      by x_orange90_x
      Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
      03-29-2025, 11:02 PM
    • netgearnetgear
      TCL 43S423 TCON OR PANEL FAULTY???
      by netgearnetgear
      Good day, I have a TCL TV: Model 43s423. After turning ON the TV, the ROKU TV logo appears with fine lines over the whole screen, then after a while there are vertical bands in the middle of the screen top to bottom and the TV tries to update its firmware but I do not have the remote to connect it to my new network connection. Also the Power ON light blinks 2 times in quick succession. When I remove the ribbon on the right of the tcon board the left side of the screen shows but with fine lines. If I remove the left side ribbon and connect the right side ribbon the whole screen is blank with...
      08-20-2025, 06:04 PM
    • advant
      Driving a Sharp TCON/panel with a universal main board
      by advant
      This thread is about trying to get an Universal Main Board to work with a Sharp TCON and panel.

      I have a Sharp LC-46D85UN TV that has had a main board issue. Since this model is from 2009, I am not able to find an exact replacement of the main board. Instead, I decided to see if I can future proof this tv by getting a Universal Main Board (T53U21.2) from China to work with the Sharp TCON (CPWBX4291TPZA) and panel. The universal main board supports a 8 bit dual channel LVDS interface whereas the TCON requires a 10 bit dual channel LVDS input. I have modded the LVDS connector to match...
      02-03-2020, 12:25 AM
    • mmartell
      General Questions on the Relationship Between Mainboard, TCON and Panel
      by mmartell
      My goal here is to be able to use boards on hand to swap into faulty sets when the faulty board is not obvious.

      I will start by asking what is the format of the output from the mainboard and is it generic in any way or does it vary by manufacturer and/or model ?
      ​
      And as far as I know a tcon and panel must be a matching pair because the timing of the signals and the voltages required to drive the panel are specific to the panel itself. (That may be a blanket statement that isn't true in some cases where the panel creates its own sub-voltages on its panel boards?)...
      01-06-2024, 01:32 PM
    • spookt
      LG OLD55CX6LA TCON Short - Help Identifying Component
      by spookt
      Hi Folks

      I've got a friend's LG OLED on the bench (well the dining table given the size of it!). It immediately powers off when turned on and sits in standby. PSU voltages are good and after disconnecting the TCON board there is stable 12V and 22V coming out of the PSU board.

      Hunting around the TCON board there appears to be a shorted power rail (DVDD09_CORE) but I'm having issues identifying the component which is shorted. I've attached a picture. It's sitting before the coil so I'm assuming it's a MOSFET of some description, but the markings I can make out don't seem...
      1 Photo
      05-24-2024, 06:27 AM
    • Loading...
    • No more items.
    Working...