The capacitor on the board was slightly bulged at the top so I replaced. Unfortunately the cap I bought on eBay was much thinner than the original, even though the spec was the same (4.7uf 100v). The problem persists. Would the thickness of the cap actually make a difference - is it worth trying to find the correct one?
-
-
Have I asked this question in the wrong place? Should I ask in the capacitor section instead? -
Post pics of the entire board. If the cap is not on a place where its ESR is too important, that smaller version could be OK.
Is this display a LED or CCFL one ? If it uses CCFLs, try testing with a spare lamp, to identify if some of the original ones are going bad.Comment
-
Thanks Rogfanther. New pic as requested. It's a W-LED curved gaming monitor.
Comment
Comment