belinea 101750, lights led once

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • senndogg
    Badcaps Veteran
    • Dec 2011
    • 383
    • Albania
    #21
    Re: belinea 101750, lights led once

    i see you were referring to one of C110 or C121 as the C15 in the schematic i supplied you.
    maybe you are right, but one thing is sure, i have not in my hands the right schematic, for the power and main board

      Comment

      • selldoor
        Slow Learner
        • Dec 2010
        • 7870
        #22
        Re: belinea 101750, lights led once

        Yes forget C15 I am not referring to c15 on the board. I am not using the schematics until we can prove it.
        Can you carefully test the voltage across the legs of the two caps c110 and c128 You have to get the polarity of the probes right.
        Please upload pictures using attachment function when ask for help on the repair
        http://www.badcaps.net/forum/showthread.php?t=39740

          Comment

          • senndogg
            Badcaps Veteran
            • Dec 2011
            • 383
            • Albania
            #23
            Re: belinea 101750, lights led once

            C121 5,6V and C110 9,6V with the main board NOT connected.

              Comment

              Previous 1 2 template Next

              Related Topics

              Collapse
              • Francesc V.
                Christmas lights - Something I am doing wrong
                by Francesc V.
                Hi:

                i am trying to repair this Christmas lights from my parents. They are incandescent lights, no led lights.

                I have tried with 12V a 24V small lights that I found in Aliexpress but is obvious that are not the right ones. They last microseconds connected. Do they blow because of Amps or Volts?

                If I measure the Amps in the string........it's only 90mA. If I measure the Volts in the "green box"......it's between 0 and 190V, but doing a little bit of maths from the number of bulbs in series.......it's only about 6V per lamp.

                Could...
                03-11-2023, 07:38 AM
              • bialag
                Lenovo ThinkPad E14 Gen 5 - Not Powering On - 3 Blinking Lights - 20 volts 0.224 amps
                by bialag
                Hello,

                I have a Lenovo here that does not want to power on. The motherboard appears to be clean, no sign of corrosion or obvious fried components. When plugged in, I see 3 blinking lights and then off. It would cycle the 3 blinking lights every 10 seconds or so as long as I have the adapter plugged in. Amp meter shows 20 volts, 0.224 amps, no fan spin, red light indicator near the charge port.

                Thermal camera shows a section of the motherboard that is warmer than the rest. It is near the connector labels JRTC1 (CMOS battery). Diode measurement to ground for pin 1 = OL,...
                03-25-2025, 05:56 PM
              • saimom
                Asus FX507ZC4 DANJLFMBAB0 REV B I need photos
                by saimom
                Hello everyone!

                Please help me determine which microcontroller was in this place.
                Logically, I guess that this is a ddr4 PWM memory controller and some kind of Richtek, but which one?
                Thise motherboard came after another service, where they say that water got on the controller and it burned down and they dismantled it.
                They did not take photos before the intervention

                The DANJLFMBAB0 REV B board, schematics, boards and photos of the motherboard were not found on the network, but I may have searched badly-((
                Maybe someone has a photo of this piece,...
                3 Photos
                12-17-2024, 08:51 AM
              • gabrielA7
                IMAC A1418 / MB: 820-00430-a / does not turn on, Lights 3 of the 4 LEDs and turns off.
                by gabrielA7
                Does not turn on, lights 3 of the 4 LEDs and turns off and stays like this, presses the power and repeats.
                I saw that the room LED lights up only when the screen is connected, so quiet.

                We have all the power supplies, even processor, 1.8V
                One thing I found strange, it has a very low resistance in the Vcore is giving 1 Ohm , work with notes and such, I know that this is normal in some processors but with this resistance only take video card so found it strange.

                I suspect that there may be some leak in the processor.
                Anyway, when I press the power, it...
                10-29-2024, 06:48 AM
              • evilkitty
                When your mom is complaining about her new cheap lights
                by evilkitty
                My Mom bought some cheap motion sensor lights on wish... then complains about about batteries and this thing chews though them, well it uses 4 AAA batteries and a pack of rechargeable ones is about 13 USD

                well since it uses 4 AAA and rechargeable are 1.2v and non-recharge at 1.5 this thing must work with 4.8-6v, I'll shove a USB cable on it, infant i will use a broken phone charge cable... dam this thing uses 430 mA and they made it battery powered...


                lets ignore the fact that i thought the board fit both ways... and the wire color is reversed going to the board...
                07-23-2024, 01:27 PM
              • Loading...
              • No more items.
              Working...