Resistor Replacement

killian6pk

Badcaps Veteran

Join Date: Apr 2010

Posts: 502

Country: USA
#1

Resistor Replacement

11-01-2011, 05:35 PM

I am working on a HannStar JC199D and have found (1) 1/8watt 10k ohm resistor that is bad. I don't have any 1/8 watt's in stock so off to RS land. If I can't find this resistor can I use a 1/4 watt in its place? I am not sure of the rules for replacing resistors. This resistor was at the lead end of the 100uf 400v cap which by the way was also bad.

Have you ever stopped to think and then forget to start thinking again?

As a very wise man once said on this forum: "Of all the things I have lost I miss my mind the most."
Tags: None
Evil Lurker

Warranty Voider

Join Date: Feb 2011

Posts: 454
#2

11-01-2011, 06:05 PM

Re: Resistor Replacement

Yup a 1/4W resistor should be fine if not better than the one installed.
Comment
killian6pk

Badcaps Veteran

Join Date: Apr 2010

Posts: 502

Country: USA
#3

11-02-2011, 12:05 PM

Re: Resistor Replacement

Thanks, here's hoping this is the end of the replacements.

Have you ever stopped to think and then forget to start thinking again?

As a very wise man once said on this forum: "Of all the things I have lost I miss my mind the most."
Comment

Announcement